Daily Questions Flashcards

1
Q

If differences exist between the maneuver descriptions in the operators manual and the ATM, what publication is the governing authority for training and flight evaluation purposes?

A

The ATM

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What aircraft or included in the same series as the MC-12W?

A

MC-12S and KA 300 equipped with pro line 21

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What operations that require P* participation Mandy in response with regards to the checklist?

A

Systems such as landing gear, flaps, auto pilot, flight management system, and the flight director

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

The recommended minimum battery voltage to start for external power is?

A

20 volts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Never connect an external power source if voltage is below what?

A

23 Volts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

The minimum N1 required to introduce fuel during a star sequence is?

A

12%

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

When are static power take off’s required?

A

They are only required when limited by accelerate stop distance and runway length. They are also required for the first flight of the day.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

At rotate what page attitude do you smoothly rotate you? What about after the gear is retracted?

A

10° 10 to 12° after gear retraction

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

When performing a normal landing, what is the standard for where you touchdown?

A

The first 3000 feet of runway beginning at the threshold. First one third of the runway when runways are shorter than 9000 feet.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

When calculating a told card, when would you recompute the data?

A

Increase in 1000 feet pressure altitude, 10°C, or 500 pounds gross weight.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Take off field line is the longest of what figures?

A

Accel Go. Accel Stop. V35

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

When does the first segment begin?

A

Extends from reference zero to the point where the landing gear completes the retraction cycle.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What are the requirements for second segment Climb gradient?

A

Airspeed = V2 Climb gradient 2.4 for VMC and 3.3% for IMC. May be greater than 3.3 on non-standard take off departures.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Define V1

A

Take off decision speed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Define VR

A

Rotation speed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Define V2

A

Take off safety speed Speed at 35 feet AGL with one engine failed.

17
Q

Define V35

A

Take off safety speed at 35 feet with both engines operating

18
Q

What is considered “payload” in weight and balance terminology?

A

Weight of occupants, cargo, and baggage

19
Q

What is the minimum airspeed during slow flight?

A

VMCA, redline

20
Q

What are the standards for steep turns? When do you begin to roll out on heading?

A

Angle of bank within 45° to 60°, desired heading +/- 10°. Left turn roll out: 20-25° Right turn roll out: 10-15°

21
Q

When using the VNAV system, what must be used as the primary altitude reference for all operations?

A

Barometric altimeters

22
Q

If there is not a rise in ITT within 10 seconds after moving the condition lever to low idle, what are your actions? ABORT START procedure…

A

Condition letter – fuel cut off. Ignition and engine start – starter only. ITT below 400°C – ignition and engine start – off. Allow five minutes before attempting another start.

23
Q

When recovering from a nose hi, airspeed decreasing unusual attitude, what bank angle will you not exceed?

24
Q

What is the redline on the airspeed indicator display?

25
When performing approaches to stall training, what airspeed is noted as being the minimum for nose up trimming?
115 KIAS
26
What are the indications of a stall?
Stall warning horn, pre-stall buffet, sloppiness in controls
27
To account for power setting accuracy and steady-state fluctuations, inadvertent torque excursions up to _______ are time-limited to _____ minutes.
To account for power setting accuracy and steady-state fluctuations, inadvertent torque excursions up to 102 are time-limited to 7 minutes.