Memory Items

Question 1

[ ] ENG AUTOSTART L,R
Condition?
Mem. Action?

Answer 1

Condition:
During autostart, one of these occurs:
• Autostart did not start the engine
• Fuel control switch is in RUN at low engine RPM with autostart switch OFF

FUEL CONTROL switch (affected side)
….Confirm…CUTOFF

Question 2

Aborted Engine Start L,R
Condition?
Mem. Action?

Answer 2

Condition:
On the ground, an aborted engine start is needed.

Mem. Item:
FUEL CONTROL switch (affected side)
….CUTOFF

Question 3

Eng Lim/Surge/Stall L,R
Condition?
Mem. Item?

Answer 3

Condition:
One or more of these occur:
•Engine indications are abnormal
•Engine indications are quickly nearing or show an exceedance
•Abnormal engine noises are heard, possibly with airframe vibration
•No response to thrust lever movement or response is abnormal
•Flames in the engine inlet or exhaust are reported

Memory:
1 A/T ARM switch 
(affected side)…Confirm…OFF
2 Thrust lever
(affected side)…Confirm…Retard until engine indications stay within limits or the thurst lever is at idle

Question 4

Eng Svr Damage/Sep L,R

Condition?
Memory items?

Answer 4

Condition: One or more of these occur:
•Airframe vibrations with abnormal engine indications
•Engine separation

Memory:
1 A/T ARM switch
(affected side)…Confirm…OFF
2 Thrust lever
(affected side)…Confirm…Idle
3 FUEL CONTROL switch
(affected side)…Confirm…CUTOFF
4 Engine fire switch
(affected side)…Confirm…Pull

Question 5

[ ] FIRE ENG L,R

Condition?
Mem item?

Answer 5

Condition: Fire is detected in the affected engine.

Memory:

Memory:
1 A/T ARM switch
(affected side)…Confirm…OFF
2 Thrust lever
(affected side)…Confirm…Idle
3 FUEL CONTROL switch
(affected side)…Confirm…CUTOFF
4 Engine fire switch
(affected side)…Confirm…Pull
5 If the FIRE ENG message shows:
    Engine fire switch
    (affected side)….Rotate to the stop
                                  and hold for 1 sec

Question 6

Dual Engine Fail/Stall

Condition?
Mem. Item?

Answer 6

Condition:
Engine speed for both engines is below idle

Memory:
1 FUEL CONTROL switches
(both)…. CUTOFF, then RUN
2 RAM AIR TURBINE switch…
Push and hold for 1 sec

Question 7

[ ] STABILIZER

Condition?
Memory item?

Answer 7

Condition:
One of these occurs:
• Stabilizer movement without a signal to trim
• The stabilizer is failed

Memory:
1 STAB cutout switches (both)..CUTOUT
2 Do not exceed the current speed

Question 8

[ ] CABIN ALTITUDE

Condition?
Memory Item?

Answer 8

Condition: Cabin altitude is excessive

Mem. Item:
1 Don the oxygen masks
2 Establish crew comms
3 Check the cabin alt and rate
4 If the cabin altitude is uncontrollable:
PASS OXYGEN switch…Push to ON and hold for 1 sec

    Without delay, descent to lowest safe alt or 10,000 ft, whichever is higher.

   To descend:
         Move the thrust levers to idle
         Extend the speedbrakes
         If structural integrity is in doubt, limit airspeed and avoid high maneuvering loads
         Descend at Vmo/Mmo

Question 9

Airspeed unreliable

Condition?
Memory item?

Answer 9

Condition:
Airspeed and Mach indications are suspected to be unreliable. (Items which can indicate unreliable airspeed are listed in the Add information section).

Objective: To identify a reliable airspeed indication, if possible, or to continue the flight using the Flight With Unreliable Airspeed table in the Performance Inflight chapter.

1 Autopilot disconnect switch…Push
2 A/T ARM switches (both)………OFF
3 F/D switches (both) ……………..OFF
4 Set the following gear up pitch attitude and thrust:
        Flaps extended ……10 deg/85% N1
        Flaps up. ………………4 deg/70% N1