Flashcards in PRM (DS 10/22/18) (ER 12/9/2019) Deck (69)
With a PRM, we only install this keypad.
Each PRM can support this many zones.
List the types of sensors (display icons) that can be programmed to the touchscreen through the PRM
door, window, motion, glass break, smoke, carbon monoxide, environmental, water, panic, duress
Number of PRMs a touchscreen will support.
The panic button can be found on this Xfinity Home device.
The backup battery used in the PRM.
These are the recommended batteries for our zigbee devices.
The range of the resistor value that must be present on a 4 wire smoke detector.
750 ohms- 10k ohms
What PRM stands for.
Panel Replacement Module
Also serves as this to improve the connectivity of the Xfinity Home security system.
The resistor rating required for a 2 wire smoke detector.
The reason Xfinity Home will no longer support legacy wireless sensors.
Legacy wireless security sensors broadcast vulnerable, unencrypted signals.
The type of power supply used for a PRM
Holding this button will enable a chime on a Zigbee Keypad.
The duration of the lockout period during PRM power up.
The number of LED lights on the PRM
Designed to save time by eliminating this step.
Programming the panel (Vista 20P)
The specifications for a siren to be compatible.
rated for 12 volts
draw less than 600mA
List the available zone functions that can be programmed to the touchscreen through the PRM
entry/exit, perimeter, 24-hour inform, trouble day/alarm night, silent 24-hour, audible 24-hour, no alarm response, silent burglary
The evaluation should take this amount of time or less.
Xfinity Home security system provides this type of encryption.
What should be done if wires are not labeled, there is no zones list provided.
Do not perform a takeover
4 wire smoke detectors can not be connected to this zone.
The transformer for a PRM must be this if it is dropped from any height.
This will be available for replacing a 6160 Alpha Keypad with a Zigbee Keypad.
Compared to a CAN, a PRM is this in a size comparison.
In order to configure a zone it will need to be this first.
All zones can be set to closed by pressing this button on the touchscreen.
Reset All Zones
All zones should be this when pairing a PRM.