Systems Review 1

Question 1

What action illuminates the TRIM OFF annunciator

Answer 1

Selecting the trim disconnect on either trim control panel

Question 2

What type of linkages are used to manually operate the primary flight controls?

Answer 2

mechanical linkages

Question 3

If the gust lock is properly engaged, how will the controls appear?

Answer 3

aileron neutral, rudder neutral, and elevator down

Question 4

What is the purpose of the elevator system?

Answer 4

controls movement of the aircraft about the lateral axis- pitch

Question 5

What are the inputs to the TAD Computer?

Answer 5

Altitude, Airspeed, Torque

Question 6

What type of hydraulic system does the T-6A use?

Answer 6

An engine-driven, closed-loop, 3000 psi +/- 120 system

Question 7

Does the emergency hydraulic system use the same set of hydraulic lines as the primary hydraulic system?

Answer 7

Separate and independent

Question 8

What is the emergency hydraulic system limited to?

Answer 8

one extension of the inboard gear doors, one extension of the landing gear, and flaps

Question 9

What is the indication that the landing gear is fully retracted and the doors are closed?

Answer 9

No lights illuminated

Question 10

T-6 flaps are _____ controlled and _____ operated

Answer 10

Electrically, hydraulically

Question 11

When does the HYDR LO caution light illuminate?

Answer 11

When hydraulic fluid is <1 QT

Question 12

When does the EHYD PX LO light illuminate?

Answer 12

When hydraulic pressure drops <2400 psi +/- 150

Question 13

The Air Data Computer provides air data outputs to the _______

Answer 13

ASI, altimeter, and VSI

Question 14

What happens when you press the HSI button on the SFIS control panel?

Answer 14

it toggles the EHSI Display between HIS and DG

Question 15

What is displayed by the electronic airspeed indicator?

Answer 15

indicated airspeed, mach number, and max operating airspeed

Question 16

What will occur when you turn the course select (CRS) knob on the EFIS Control Panel

Answer 16

It rotates the course pointer and digital course readout on the EHSI to desired course

Question 17

Various pilot warning tones are output by _____ located _____.

Answer 17

an electronic tone generator, in the AOA computer under the front cockpit glare shield

Question 18

What does the 18 unit mark on the AOA computer indicate?

Answer 18

Stall speed

Question 19

What is the guard frequency on the VHF radio?

Answer 19

121.5- to monitor make sure that this is the active chanel

Question 20

What does selecting the ALTN button do?

Answer 20

bypasses the audio amplifier, so volume and amplification control will be lost on the UHF radio

Question 21

How do you switch between active and standby UHF radio frequencies on the RMU?

Answer 21

Press the transfer switch adjacent to the UHF display

Question 22

Where DME information is automatically displayed when VOR/DME is tuned into the RMU and VOR is the selected NAV source

Answer 22

DME information is automatically displayed in the EHSI

Question 23

Where is the GPS Display unit located

Answer 23

Left side of the instrument panel in each cockpit

Question 24

What is the purpose of the rudder?

Answer 24

to rotate the aircraft around the vertical axis (Yaw)

Question 25

What does the primary hydraulic system operate?

Answer 25

Landing gear, main inboard gear doors, NWS, flaps, speed break

Question 26

What is the main purpose of the flaps?

Answer 26

decrease airspeed on landing, decrease landing roll

Question 27

the engine-driven hydraulic pump charges the _______ with 3000 psi of hydraulic pressure on engine start up

Answer 27

Emergency accumulator

Question 28

When does the speed break retract?

Answer 28

the speed brake switch is moved forward, flaps are extended, or PCL is moved to max

Question 29

In the T-6A both pilots have the capability to navigate _____ and to fly _____ approaches

Answer 29

VOR, VOR or ILS

Question 30

When you are requested to “Squawk Altitude” (Mode C) on your transponder, press the ____ on the RMU to change the mode from ____ to _____.

Answer 30

Press the field select switch to change mode from ON/STBY to ALT

Question 31

What are the standby flight instruments?

Answer 31

mag compass, airspeed indicator, altimeter, turn and slip indicator, and altitude indicator

Question 32

Where is the audio control panel located?

Answer 32

left console panel of each cockpit

Question 33

What lights do you get when you pull the emergency LDG handle?

Answer 33

Three green lights (LDG is down and locked)\

2 red lights (inboard gear doors are open)