Warnings Flashcards
The _____ have a fire detection system; however, there is no fire extinguishing system installed.
main gear wheel wells
What happens after the CARGO FIRE DISCH switch is pushed?
All extinguishers are committed to the selected compartment.
What occurs when an engine fire extinguisher is discharged?
The ENG BTL (1 or 2) DISCH light illuminates.
The APU Fire Warning Horn in the nose wheel well sounds ______.
intermittently during ground operation to indicate an APU fire or fire test
Which of the following occurs if an engine overheat is detected?
An EICAS caution message displays.
If the FIRE/OVHT TEST switch is released with FIRE TEST IN PROG message displayed ____.
the test ends without completing
If the FIRE/OVHT TEST switch is released with the FIRE TEST IN PROG message displayed, the test ________.
ends without completing
An altitude alert occurs when the airplane altitude deviates from the altitude selected on the MCP by ______ feet or more.
200
Altitude alerting is inhibited in flight with landing flaps (25 or 30) selected and all landing gear down, or ______.
POSSIBLE ALTERNATE WORDING: The altitude alert system is inhibited in flight when _____.
glideslope capture
What does pressing either Master WARNING/CAUTION Reset Switch do?
Silences certain warning sirens and resets the lights for subsequent warning alerts.
Status messages identify system faults which may affect _______.
airplane dispatch
If a fault is detected in one of the engine’s fire detection loops, ______.
the system automatically switches to single loop operation
Pushing the CARGO FIRE DISCH switch on the ground causes the immediate full discharge of two extinguisher bottles into the selected compartment. After a time delay, _____.
one of the (200A/B/C) three remaining (322) four remaining extinguisher bottles is discharged into the selected compartment at a reduced rate of flow
A Ground Proximity Warning of DON’T SINK, DON’T SINK indicates that the GPWS detects ___
an altitude loss after takeoff or go-around
The STATUS message cue, communication messages (except CABIN ALERT), and communication aural chimes are inhibited on descent from 800 feet RA until below ____ knots groundspeed.
75
Takeoff configuration warnings are inhibited when airspeed exceeds ______.
V1
Takeoff configuration warning indications are ______.
inhibited above V1
The main wheel wells have ______.
fire detection capability only
Which of the following statements is true regarding Aural Alerts?
A Bell is used for fire warnings.
During a manual fire and overheat detection system test, _____.
FIRE TEST IN PROG appears on the EICAS
The Predictive Windshear System (PWS) is activated automatically on the ground when the ___.
throttles are set for takeoff
After engine start, the blue STATUS cue is inhibited ______.
until 30 minutes after liftoff
What level of fire detection does the nose wheel well have?
No fire detection capability
Illumination of the ENG BTL 2 DISCH light on the engine fire panel indicates ______.
low pressure in the number 2 extinguisher