ANTI ICE Panel Flashcards

1
Q

What is accomplished if the WING anti ice pushbutton is selected ON while the aircraft is on the ground?

A

The system will self-test for 30 seconds, and then the valves will close until the aircraft is airborne.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What does the WING FAULT light illumination on the ANTI ICE panel indicate?

A

• Valve disagreement. (comes on momentarily when valve in transit) • Low pressure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What does the ENG 1(2) FAULT light illumination on the ANTI ICE panel indicate?

A

Valve disagreement (comes on momentarily when valve in transit)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Describe the PROBE/WINDOW HEAT logic.

A

Probes and window heat come on automatically with at least one engine running or aircraft airborne. The switch should be in AUTO for T/O.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What part of the wing is heated?

A

Outboard 3 slats

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

In what position do the WING and ENGINE anti ice valves fail if electrical power is lost?

A
  • Wing – valves CLOSE

* Engine – valves OPEN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is the significance of high swept wings versus less swept wings in ice accumulation?

A

The more swept the wing, the less time for the moisture to attach.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

A flight crew is arriving to the aircraft in DTW early in the morning and notice that cockpit windows are frosted over. What should the flight crew do?

A

Select the PROBE/WINDOW HEAT on. This must be selected off prior to takeoff in order to regain normal system logic.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The temperature outside is 2°C with visible moisture. What should the flight crew turn on?

A

ENG anti ice after engine start.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

After takeoff, when should the flight crew turn on the WING anti ice?

A

WING anti ice can be used after the aircraft is in a clean wing and when conditions warrant its use.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Climbing through FL240 in visible moisture, the crew notices the TAT is - 22°C and the SAT is -45°C. What would be appropriate use of the ENG anti ice?

A

Engine anti ice may be turned OFF in this scenario. Engine anti ice is required when icing conditions exist or are expected except during climb or cruise when the SAT is below -40°C.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Starting a descent out of FL350 with visible moisture, the TAT is -32°C and SAT is -53°C, what would be appropriate use of the ENG anti ice?

A

Engine anti ice should be turned ON in this scenario. Engine anti ice is required when icing conditions exist or are expected except during climb or cruise when the SAT is below -40°C.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Descending through 10,000ft, the pilots notice ice accumulation on the cockpit windshield blades. What should they do?

A

Turn on the WING anti ice. WING anti ice may either be used to prevent or remove ice accumulation from the wing leading edges. After takeoff, WING anti ice can be used after the aircraft is in a clean wing configuration. Ice accumulation can be detected by observing the ice indicator located between the two cockpit windshields or by observing the windshield wipers blades.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Can the WING anti ice be used on the approach and landing?

A

Yes but remember second segment climb performance could be affected if a go-around is performed.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What is TAT?

A

Total Air Temperature is also called Indicated Air Temperature (IAT) or Ram Air Temperature (RAT)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What is SAT?

A

Static Air Temperature is also called: Outside Air Temperature (OAT) or True Air Temperature

17
Q

Should a flight crew use TAT or SAT when determining whether to turn anti ice systems on?

A

Remember TAT indicates when to turn anti ice ON. SAT indicates when it may be able to be turned OFF (in Climb or Cruise).

18
Q

What is the difference between TAT and SAT known as?

A

The difference between TAT and SAT is called “ram rise (RR)” and is caused by compressibility and friction of the air at high velocities.

19
Q

After selecting the PROBE/WINDOW HEAT pb on the ground to remove ice or fog on the window. Would the pilot need to select it off before T/O?

A

Yes, so it can operate in the AUTO mode in order to regain normal system logic.