20 - Eat 5

Question 1

To prevent a return line in a reservoir from bottoming, it is often cut off at an angle of _____ degrees. A) 90 B) 45 C) 60 D) 30

Answer 1

B) 45 pg 95

Question 2

An adequate reservoir size for a 10 GPM pump would be ____ gallons. A) 10 B) 15 C) 30 D) 60

Answer 2

C) 30                                                                  10 GPM x 3 = 30 Gallons 
Tank size (gallons) = Pump GPM x (2 or 3)                                                             pg 99

Question 3

The plate that prevents the return fluid from recirculating directly back to the inlet is called the_______. A) Breather B) Mesh C) Baffle D) Mounting

Answer 3

C) Baffle pg 95

Question 4

The returning fluid to the reservoir is usually ______ than the supply fluid. A) Cooler B) Less C) Cleaner D) Warmer

Answer 4

D) warmer pg 95

Question 5

The filler hole in a reservoir is provided with a ________ screen. A) Breather B) Removeable C) Micron D) Filter

Answer 5

B) removable pg 94

Question 6

Reservoirs are made with connections on top that are set on ______ to keep out contaminants. A) Baffles B) Risers C) Plates D) Fittings

Answer 6

B) Risers pg 95

Question 7

What is not one of the three most common standard reservoir designs? A) L-Shape B) Overhead Stack C) Flat Top D) Wedge Shape

Answer 7

D) Wedge Shape pg 95,96 & 97

Question 8

Fluids with a ______ viscosity index must be kept warm by heaters. A) High B) Reduced C) Low D) Surface

Answer 8

C) Low Low Viscosity = Thick
High Viscosity = Thin pg 99

Question 9

Reservoir temperature is controlled by? A) Water coolers B) Heaters C) Air coolers D) All of the Above

Answer 9

D) All of the above pg 99

Question 10

For reservoir modifications an overcapacity of at least _____ should be provided. A) 15% B) 25% C) 10% D) 20%

Answer 10

D) 20% pg 99