After Run-up

Question 1

Set Radios (Typical setup CYCC-CYOW-CYCC round robin)

Answer 1

COM 1 active, local Freq (CYCC Radio) 122.775
COM 1 stdby, after T/O terminal Freq (CYOW term) 127.7
NAV 1 active, enrout Nav Aid (YOW VOR) 114.6
NAV 1 stdby, ILS at first destination (ILS 32 CYOW) 110.3

COM 2 active, ATIC for 1st destination (CYOW ATIS) 121.15
COM 2 stdby, ATIS for return (KMSS ATIS) 128.075
NAV 2 active, same as NAV 1 114.6
NAV 2 stdby, same as NAV 1 110.3

Set ADB if applicable (YRR NDB) 377

Question 2

Call for IFR Clearance

Answer 2

After clearance readback set transponder code

Question 3

Load Flight Plan

Answer 3

CYCC-YOW-CYCC

Question 4

Load emergency return Approach

Answer 4

Approach is for the SAME rwy that was used for T/O.
Verify approach is loaded properly by scrolling through the waypoints

Question 5

Perform T/O briefing from Airport chart or SID chart

Answer 5

set Heading bug outbound Course on HSI

Question 6

Taxi out

Answer 6

Perform Instrument Checks

Turn and bank, Ball, HSI, AI, VSI and Compass
i.e Wing left, ball right, DI decreasing, AI and VSI stady and Compass free and moving

Question 7

Before Take-off

Answer 7

Record time for Bingo time

Question 8

After Take-off

Answer 8

Track outbound when altitude permits or as per clearance.

When instructed to proceed on course you must intercept the radial and not go Direct To.

Advice CYCC radio that you are leaving the area.

Instructor or Examiner will instruct you when to change to next frequency.

Question 9

Level Off

Answer 9

Perform Cruise Check.

Listen to ATIS for next destination.

Question 10

Based on ATIS decide on approach to be used and,

Answer 10

Brief the Approach

Tune and Identify long range nav aids (VOR and ADF)

Load Approach in Garmin 430

Question 11

When reporting to terminal area controller

Answer 11

Report:
Aircraft ident
Altitude
ATIS info

i.e: Piper Seminole CF-GKD at 3000’ with ATIS information “C”

ATC will ask to Squak and intentions

Question 12

If the case of an ILS approach with radar vectors

Answer 12

Upon receiving radar vectors:

Select ILS frequency
Identify
set VLOC
set final approach Course (for NAV1 and NAV2)
activate approach

Follow instructions to fly the approach. Proceed as per profile shown at Figure 1

Question 13

On return to CYCC, repeat procedure as above

Answer 13

Cruise check
Listen to ATIS
Brief Approach
and Load approach in Garmin 430

Question 14

When given a hold verify that it does not exceed the bingo time

Answer 14

Determine type of entry and first heading outbound
Use OBS Button as applicable

(EOSAFE)