TB Forcible Entry 1&2

Question 0

All of these steps used when forcing a door with a Fox lock are correct except:
A. Identify a Fox lock by the cylinder in the center of the door covered by a metal plat and four bolts
B. Sheer off the bottom 2 bolts and one bolt at the top
C. Swing the plate to the side
D. Pull the cylinder
E. Use the square key tool and turn away from the bottom bar

Answer 0

A and E are incorrect
A. Sheer top 2 bolts and one bottom bolt
E. Use square key and turn toward the bottom bar

Question 1

T/F When forcing an outward opening door with the fork end of the halligan, the concave side of the fork should be placed toward the door with the tool slanted slightly

Answer 1

True

3.1, A2

Question 2

When facing doors with 2 locks, what is the correct placement of the halligan tool?

Answer 2

Tool between 2 locks

FE 1, 2.1 B note

Question 3

FF Santoli has successfully pulled the cylinder of a mortise lock using the K-tool.  After inserting the key tool into the lock through the cylinder hole, with the bent end FF Santoli would be correct in moving the bolt slide from the:
A. 6 o clock to 12 o clock position
B. 5 o clock to 7 o clock position
C. 1 o clock to 3 o clock position
D. 3 o clock to 5 o clock position

Answer 3

B. 5 o clock to the 7 o clock position or vice versa

FE 4.2, A2

Question 4

When forcing a multi lock door by cutting a hole in the door, what would the correct way to make such a hole?

Answer 4

Cut a triangle in the lower quadrant of the door on the doorknob side. Make the hole large enough to get your arm through and back out, but small enough so that you don’t cut the bar
FE 9.1 note

Question 5

T/F. When operating at an incident with an electronically operated security door, it would be correct to push the lever that changes the operation from electrical to mechanical away from the chain hoist

Answer 5

False. The lever should be pushed toward the chain hoist

FE 10.1 C

Question 6

When attacking a door from the hinge side, what hinge should be attacked first?

Answer 6

Always attack the upper hinge first so that heat and smoke will rise while completing forcible entry on the bottom of the door
FE 1.1 C note

Question 7

What tools can be used to cut a padlock?

Answer 7

Halligan, duck bill, bolt cutter, saw w/ aluminum oxide blade, cutting torch, bam bam tool
FE 5.1 C

Question 8

What tools can be used to cut an American Series 2000 lock?

Answer 8

Saw w/ aluminum oxide blade, cutting torch

FE 6.1 B

Question 9

What are the 3 types of security gates found throughout the city?

Answer 9

Manually operated
Mechanically operated
Electrically operated