350-601 VOL2 Flashcards
(18 cards)
What is the minimum configuration needed to configure the export parameter for Flow Exporter
on Nexus 9K?
B. switch(config)# flow exporter flow-exporter-one
switch(config-flow-exporter)# destination 10.1.1.1
switch(config-flow-exporter)# source ethernet 1/1
Name the policy that determine the connections and the network communication resources
between the server and the SAN on the network. These policies are included in service profiles
and service profile templates, and can be used to configure multiple servers.
B. SAN Connectivity Policy
Select the two options from below that need to be configured before you start deploying ACI
Layer 4 to Layer 7 services. (Choose two)
A. At least one bridge domain
D. An application profile
You are a network admin and you have been assigned a tasks to deploy Layer 4 to Layer 7 services.
Select the correct options from below that you will perform. (Choose two)
B. Import a device package
C. Register the device and the logical interfaces
You are a network admin and you have configured Netflow on a switch. You want to monitor the
NetFlow parameter on the switch where it shows you SIP, DIP, S-Port, D-Port, Byte Count & Packet
Count. Which command will you run from the below options to get these details at once?
C. Show flow cache
You have Cisco ACI running in your network. You have to configure route peering. Select the
protocols that supported for route peering. (choose two)
B. OSPF
C. iBGPv4
Before you upgrade or downgrade firmware in a Cisco UCS domain, select the two correct options
from the below options that you will follow. (Choose two)
A. Review the release notes
C. Back up the configuration into an All Configuration backup file.
Name the policy that contains a collection of target storage ports on storage array that you use
to configure fibre channel zoning.
C. Storage Connection Policy
A network engineer is trying to configure Netflow on a Cisco Nexus 7000 Series Switches using
NX-OS, but none of the CLI commands are working to do this. What must be configured first
before Netflow configuration commands are available on the Nexus 7000?
C. Feature netflow
You have configured HSRP version 2 on a Cisco device to provide for router redundancy on a LAN
segment. Group 12 was used for the HSRP instance. After this, what virtual MAC address will
the hosts on the LAN use as the default gateway?
B. 0000.0C9F.F00C
What feature has been implemented with this command?
B. Loose uRPF
A network administrator must specify the EPG Policy Resolution Immediacy parameters to
determine when a policy should be pushed to the leaf switches. Which of the following are valid
options for this? (Choose three).
A. Pre-provision
C. Immediate
E. On Demand
You have been tasked with installing a software maintenance upgrade to a Cisco NX-OS device.
The image has already been added to the hard disk. Which command is used to install this image?
A. Install add
Which of the following OSPF LSA types can only exist in a not-so-stubby area (NSSA)?
D. Type 7
Which of the following OSPFv2 authentication methods are supported by Cisco NX-OS? (Choose
two).
A. MD5 authentication digest
C. Simple password authentication
A network administrator configures BGP. He wants to establish a TCP connection between peers
that can send incremental updates only when a change occurs in topology or routing policy.
Which TCP port can be used in this scenario?
A. TCP port 179
In which of the following scenarios does BFD send a failure detection notice to BFD-enabled
protocols?
B. Detects a failure in the forwarding path
Which configuration tasks trigger the automatic MLD process on a device using IGMPv2? (Choose
three).
A. Enable PIM6
C. Enable link-local group reports
D. Statically bind a local multicast group
