Approach Procedures Flashcards
When flying an approach, when must VOR/LOC be selected by? Are there any exceptions to this?
By the IAF. the exceptions are when flying an RNAV approach, DME/GPS arrival When flying a STAR that leads into an approach, the PF can leave map mode until turning into final, but the PM should be in VOR/LOC from the IAF.
How do you load a STAR into the FMS?
Ensure airport identifier is last waypoint in FMS.
FPL MENU ARRIVE to load approach, PM to review FPL SUMMARY page
Ensure no GAP or NO LINK entries.
Is there a requirement to review the STAR loaded?
Yes, during the arrival briefing PF to read arrival waypoints, bearing and distances. PM to confirm accuracy on their FMS.
What is the order of approach by preference?
Coupled ILS
RNAV
Runway aligned approach
Circling approach
Are there any requirements on doing a flap 35 landing off an instrument approach?
Only done if visual below 1000ft.
What are some things to consider/do when briefing an ILS approach
Marker Sense switches to low, MKR audio on, DME to HOLD if required DH 150FT Flight director kept until after touch down
What the the criteria for a stable approach?
Stable by 1000HAT for runway aligned approaches in IMC and 500HAT for all other approaches.
Aircraft on correct path with only small heading and pitch changes
Airspeed Vref to Vref +25
Aircraft in landing configuration
Max 1000FPM sink rate
Normal power setting for config and above idle
Briefings and checklists completed
For circling or visual approach, aligned with runway by 400HAT
When is Vref or Vref+ additives to be achieved by? What additives can be made to Vref?
50ft
1/2 gust factor up to 10kts and up to 10kts for Windshear. Additives are cumulative up to 15kts.
Don’t adjust red bug for additives.
What is the maximum pitch attitude on touchdown?
8 degrees for a 200
6 degrees for a 300
if a go around is required, what is the procedure?
PF calls "Go around, set power" PM sets go around power PF calls "gear up" PM selects gear up "selected" then automatically sets altitude pre selector (should be set already) HDG/NAV if RNAV, IAS, Alt sel and calls "HDG/LNAV, IAS,...SET ALT SEL ARMED" take off normal from there.
How is a go around with no change conducted? Is there any restrictions?
PF calls “going around, set power, no change”
PM sets power and calls “power set” then automatically sets altitude (circuit or circling), HDG, IAS and ALT SEL and calls “HDG, IAS,… SET, ALT SEL ARMED”
Approaching circuit height, PF levels aircraft off and sets approx 40%