A/O Exam Questions Flashcards
(144 cards)
When SHALL the glucometer be tested to verify equipment’s ability to accurately sense very low or very high glucose levels?
Each Monday Morning
Who makes modifications to the Rules and Regs?
Fire Commission
How long should the Onan Generator be ran for without a load before shutting down?
3 to 5 minutes
What is the fuel/additive mixture of 2-stroke engines?
50 to 1
On newly issued wooden ladders, how many coats of varnish should they be finished with?
2 coats
When SHALL 3” ladderpipe hose be tested and at what psi?
Tested Annually and After repairs
300 psi
Which tip SHALL ladderpipe stream straighteners be used with?
Straight
The apparatus with the good battery SHALL run at what rpm’s when jump starting a bad battery?
1,000 - 1,500 rpm
What are Facades supported by?
Post
Pillars
Other means of decoration
What is the maximum inches of wood a Tiger Saw can cut through?
12 inches
What are the SKED lifting straps rated up to?
9,000 lbs
How many teeth in a row must be damaged to take a chain out of service?
3
How many total number of teeth must be damaged to take a chain out of service?
6
What is the compressor regulator set to when power lubing the front and tiller suspension?
60 psi
What type of grease is used to lube the suspension?
Black Pearl
Which type of cut is used to cut a triangle piece of roof covering to expose the sheeting?
Plug Cut
How far are laminated beams spaced apart?
12 to 40 feet
The aerial ladder SHALL be lubed no sooner than how many days prior to Aerial Ladder Test?
14 days
How many cubic feet of compressed air does a 45 minute SCBA cylinder hold?
65.6 cubic feet
How many cubic feet of compressed air does a 1 hour SCBA cylinder hold?
87 cubic feet
How can the ground cable be identified?
One attached to Vehicle Body/Frame
What two toxic gases can freon gas produce when heated to the point of decompsition?
Phosgene & Fluoride
What is the burst strength requirement of a Polyethylene Pipe?
Excess of 800 PSI
What process is used when a pipe is joined to produce a joint stronger than the pipe material?
Heat-fusion