CB 2016 Flashcards
(27 cards)
What is the purpose of the drive shaft damper (snubber) installed on drive shaft section No3 and No4?
Dampen radial movements of the shaft at speeds that cause harmonics
Why does the FADEC´S provide torque, engine temperature, Np, Ng and fuel flow to the AFCS?
To limit the collective axis when coupled to altitude or vertical speed modes
What aircraft systems will provide/compute the data for the IVSI?
The indication is based on the ADC and computed by the AHRS
What is the normal Alignment time for the AHRS on the ground and in the air?
30 sec on ground and 2 min in air
What is the transponder code for Radio com failure?
7600
Give a statement of intent in case of major malfunctions before TDP/COMMITTED
LANDING
At which altitude do you set 1013 on your altimeter climbing to a FL, offshore?
at 3000´
What is Vmini (minimum airspeed for instrument flight)?
50 KIAS
What is maximum airspeed power off?
120 KIAS
What is maximum wind speed for rotor engagement?
45 kts
What is maximum allowed fuel imbalance between fuel tanks?
700 lbs
In regard to a cruise flight offshore, what is the dimension of the cylindrical area above a flare stack, where no flight operation shall take place?
Height 1500 ft
Radius 150 m
A helideck is per definition a unstable/moving landing area when the…
pitch and roll exceed 1 degree either side AND the vertical movement exceeds 2 meters
What is the standard speed for IMC approaches?
100 KIAS
In regard to the Communication with ATC, what are the phrases to be used when a TCAS RA is commenced and after its completion?
“BHLxxx, TCAS RA Climbind/Decending” - “BHLxxx, RA complete, descending/climbing to x thousand feet”
The yellow INTEG caution is illuminated. Are you allowed to fly a RNAV approach?
NO
The position reports on an offshore shall contain the following information?
callsign, position and time, altitude/flightlevel, ETO next reporting point, next reporting point of it is a special point
The Fuzz Burn feature on the Chip/Temp detectors are deactivated when:
When the Oil HOT caution is activated
Are you allowed to take off with the following MFD configuration? Left outboard; PFD Left inboard: EICAS Right inboard: PFD Right outboard: NAV
NO
What would happen to the engine if both channels on that engine where to fail? FADEC 1A FAIL and FADEC 1B FAIL?
The engine would shut down
What is standard call when PM considers action is required to avoid contact with surface, both for PF and PM?
PULL UP
What will be your action if you get a full scale deviation on localizer on an ILS approach below 500 ft?
Execute Missed approach
On an ARA approach is the maximum tailwind component limited to
10 kts
What is the minimum speed to use the Go Around button?
50 KIAS
