Cultured Marble/Cabinets

Question 1

Cultured marble wall panels are to be installed plumb/level within _______ of an inch.

Answer 1

1/4”

Question 2

Cultured marble wall panel thickness can vary +/- ______ of an inch.

Answer 2

3/16”

Question 3

Pony wall panels are to be wrapped with cultured marble using ______ degree cuts.

Answer 3

45˚

Question 4

Pony wall caps, window sills, shower seats are to be pitched toward the drain a minimum of _______ of an inch on surfaces 10” or less, and _______ of an inch on surfaces greater than 10”.

Answer 4

1/8”

1/4”

Question 5

Cultured marble vanity tops are not to be bowed/warped in excess of _________ of an inch per foot.

Answer 5

1/16”

Question 6

Vanity tops NOT installed wall to wall are to be caulked to the __________ at the open end.

Answer 6

Cabinet

Question 7

Cultured marble is to be viewed from a distance of ________ feet.

Answer 7

3’

Question 8

All exposed edges of marble tops to be completely ____________.

Answer 8

Finished (gel coat)

Question 9

Cabinets are to be viewed from a distance of _______ inches.

Answer 9

18”

Question 10

What’s the tolerance on cabinet drawers rolling smoothly with no binding?

Answer 10

No tolerance

Question 11

Door/drawer fronts are to align with each other within ________ of an inch.

Answer 11

1/16”

Question 12

There should be a minimum of ________ bumpers per cabinet drawer.

Answer 12

2

Question 13

Chips, dings, and scratches on cabinet drawer boxes and inside cabinets can be puttied up to ______ of an inch.

Answer 13

1/16”

Question 14

Cabinets doors less than _______ feet tall are to have a minimum of _______ bumpers.

Answer 14

4’

2

Question 15

______________ are to be installed on all cabinet doors over 4’ tall.

Answer 15

Latches

Question 16

What’s the tolerance for cabinet doors that rattle?

Answer 16

No tolerance

Question 17

Warped cabinet doors are not to exceed ______ of an inch.

Answer 17

1/8”

Question 18

_________ clips installed at each end of a cabinet shelf, and ________ clips at the center of the shelf.

Answer 18

2

2

Question 19

What do we do with delamination of melamine on cabinets?

Answer 19

Replace

Question 20

The minimum length for a piece of cabinet trim (crown, M1, etc.) is?

Answer 20

2’

Question 21

All nail holes and unused screw holes in cabinets are to be _________.

Answer 21

Puttied

Question 22

All _________ to be cut flush with the cabinet box.

Answer 22

Shims

Question 23

All plumbing and electrical cutouts inside cabinets to be cut _______.

Answer 23

Tight

Question 24

What’s the tolerance for blemishes of any kind in the finish on cabinets?

Answer 24

No tolerance

Question 25

What do you do if your cabinet has water damage?

Answer 25

Re-skin or replace it

Question 26

Wood tops to be cut tight to the drywall with a maximum gap of _________.

Answer 26

1/8”