Gas systems and Vaporizers Flashcards

1
Q

Thermal conductivity

A

a measure of speed with which heat flow through a substance

*higher thermal conductivity, the better the substance conducts heat

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

PISS for Oxygen

A

2-5

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Isoflurane (20°C)

A

240 mmHg

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Critical temp of O2

A
  • 118.6°C
  • bc ambient/room temp (20C) is above oxygens CT, it CANNOT be stored as liquid, no matter how much pressure we apply.
  • HOWEVER, the main supply of oxygen in a hospital is in liquid oxygen stores. The containers are insulated from the outside and the temp is kept at -160C.
    • ie: ambient temp is below O2’s CT, so if you apply enough pressure, you can make it a liquid.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Enflurane Vapor pressure (20°C)

A

172 mmHg

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Changes in altitude

A

Increase altitude, decrease barometric pressure

decrease altitude, increase barometric pressure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Gas/tank color blue

A

Nitrous oxide

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Latent heat of vaporization

A

Number of calories required to change one gram of liquid into vapor without a temperature change

  • the energy comes from the liquid itself or an outside source
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Halothane (20°C)

A

244 mmHg

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Changes in altitude

A

Increased altitude, decreased barometric pressure, increased concentration of inhaled gas put out through vaporizer

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Safe handling of cylinders

A
  1. never stand cylinder upright without support
  2. never leave empty cylinders on the machine
  3. lever leave the plastic tape on the port while installing the cylinder
  4. never rely only on the cylinder’s color for id of contents
  5. never oil valves
  6. “crack” the valve first to remove particles of dust or other crap.
  7. valve should always be fully open when a cylinder is in use
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

gas/tank color yellow

A

air

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Vaporization

A

Conversion of a liquid to a gas

molecules combard the surface of the liquid and the walls of the contaner creating a vapor pressure

Dependent on:

  • vapor pressure
  • temperature
  • amount of carrier gas used
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Cylinder tag

A
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Gas/tank color brown

A

Helium

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Nitrous oxide:

liters

pressure

A

1590 L

750 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

copper kettle

A
  • measured flow, bubble through
  • dedicated flowmeter for kettle
  • gas comes up through central tube inside vaporizer to the loving cup
  • flow of gas is then directed down toward the liquid (bubble through)
  • highly concentrated vapor then exits the vaporizer and is diluted into the fresh gas flow
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

Air cylinder:

liters

pressure

A

625 L

1800 psi

19
Q

Changes in Altitude- Effects on Vaporization

A
  • vaporizers must be re-calibrated to assure accurate % delivered aneestheic gas
  • the % delivered is relative to the agent’s vapor pressure in comparison to the barometric pressure:

Vapor pressure

barometric pressure

20
Q

Gas/tank color grey

A

CO2

21
Q

Altitude effect on Vaporizers

(variable bypass vs TEC 6)

A

Variable Bypass

  • effect is that you are delivering a higher concenration of volatile agent at higher altitudes (lower barometric pressure), but maintaining the same partial pressure
    • automatic

TEC 6

  • Effect is that you would have to deliver higher dialed concentration of Des at higher altitude/lower baro pressure
  • you would alter your concetraiton dial to decrease output in lower altitude to avoid delivering overdose of anesthetic
    • you must change the concentration dial
22
Q

Vapor pressure

A

Caused by the gas molecules hitting the surface of the liquid and the walls of the container

23
Q

Oxygen cylinder:

liters

pressure

A

625 L

2000 psi

24
Q

PISS for CO2

A

1-6

25
Q

Desflurane (20°C)

A

669 mmHg

26
Q

variable bypass vaporizer

A
  • a portion of the gas flow will pass into the vaporizing chamber where it will become saturated with vapor
  • vapor-laden portion then rejoins the gas flow for dilution to deliverable concentrations
  • altitude effect: deliver a higher concentration at higher altitued/lower barometric pressure but mainain same partial pressure
27
Q

DOT permanent markings

A
  1. serial number
  2. service pressure in psig
  3. manufacturer and serial number
  4. “SPUN” indicates the end of cylinder was closed by a spinning process
  5. initial qualifying date
  6. ”+” indicates cylinder is authorized for charging up to 10% above marked service pressure.
  7. Star indicates cylinder may be retested every 10 years instead of 5
28
Q

critical temp of N2O

A

36.4°C

  • bc abient room temp (20C), is below N2O’s CT, it can be liquified with enough pressure applied to it
  • that’s why we store N2O at room temp as liquid under 745psi (in the cylinder)
29
Q

Sevoflurane (20°C)

A

160 mmHg

30
Q

PISS for air

A

1-5

31
Q

potential vaporizer hazards

A
  1. wrong agent in the vaporizer
  2. contamination- close lid quickly to keep crap out
  3. tipping
  4. overfilling
  5. simultaneous admin of more than one vapor
  6. leaks
  7. pumping effect- sputtering, like when sinks are off and turned back on again.
32
Q

Specific heat

A

The number of calories required to increase the temperature of one gram of a substance one degree C

*can be liquid, solid, or gas

specific heat of an anesthic agent indicates how much heat must be added in order to maintain a constant rate of vaporization

33
Q

boiling point

A

when vapor pressure = barometric pressure

34
Q

PISS for Nitrous oxide

A

3-5

35
Q

Cylinder labels

A
  1. hazard class
  2. type of gas
  3. statement of hazard and measures to avoid injury
36
Q

gas/tank color green

(international white)

A

Oxygen

37
Q

Temperature and vaporization

A

direct relationship

increased Temp, increased vaporization

38
Q

critical temperature

A

the temp above which a gas cannot be made into a liquid no matter how high the pressure

** a gas CANNOT be liquified if the ambient temp is greater than the cricital temp (ex: oxygen: CT -118C)

** A gas CAN be liquified if the ambient temp is below the cricical temp (ex: Niitrous Oxide: CT 36.5C or 39.5C depending on slide)

39
Q

TEC 6

A
  • special vaporizer for desflurane
  • “atmospheric pressure” within vaporizer increased to 2 atm by using heat (39C)
  • requires a plug, will feel warm compared to other vaporizers
  • altitude effect: you have to deliver higher dialed concentration of Des at higher altitude.
40
Q

Gas/tank color black

A

Nitrogen

41
Q

DISS

A

Diameter index safety system

  • provides non-interchangeable connections for the medical gas lines
  • consists of body, nipple, and nut
  • only properly mated parts will fit together and allow the threads to engage
  • required on every anesthesia machine.
42
Q

PISS for heliox

A

2-4

43
Q

Regulatory Agencies (3)

A
  1. FDA- enforces purity of medical gases
  2. United States Pharmacopoeia- specifies purity of medical gases
  3. Department of Transportation- establishes requirements for medical gas cylinders and containers
    1. manufcturing
    2. filling
    3. qualification
    4. transportation
    5. storage
    6. handling
    7. maintenance
    8. re-qualification
    9. disposition
    10. labeling