"General knowledge"

Question 1

What bleed air services are lost following an engine failure?

Answer 1

OBOGS, pressurisation, heating, defogging, canopy seal and anti-G

Question 2

What are the four devices operated by the hydraulic system under normal operations?

Answer 2

Landing gear/main gear inboard doors, flaps, speed brake, NWS

Question 3

Which element of the hydraulic system is responsible for activating the corresponding actuator when selecting a cockpit control to lower the flaps?

Answer 3

Electrical selector valves

Question 4

Which of the following statements is correct?

Answer 4

When set to TR+G, COM2 will not receive on the Guard frequency 121.500 MHz if set to a frequency of 255.875MHz

Question 5

When switched on, the navigation lights are…

Answer 5

Constantly illuminated

Question 6

Battery bus circuit breakers are located on the ____ hand side console in both cockpits

Answer 6

Left

Question 7

What indicates an open bus tie switch?

Answer 7

A yellow BUS TIE message on the CAS

Question 8

An inward facing green chevron on the UFCP indicates

Answer 8

A selectable option is available

Question 9

In above mode, traffic that is between ____ ft above and ____ ft below the aircraft is displayed

Answer 9

8700
2700

Question 10

What effect will rotating the bypass switch to the EMR position have on the V/UHF radio?

Answer 10

The audio will be unamplified and raw

Question 11

Which pressurization switch position opens the control valve, allowing bleed air inflow to continue without opening the fresh air valve?

Answer 11

DUMP

Question 12

What action(s) should you take if you discover zeolite dust in your oxygen mask?

Answer 12

Activate your emergency oxygen supply, descend to 10,000 ft and disconnect oxygen hose from the CRU-60

Question 13

The master warning and master caution lights are interconnected with the ?

Answer 13

Crew Alerting System (CAS) messages

Question 14

Which controls determine how much hot engine bleed air is provided to the ECS?

Answer 14

TEMP CONTROL, BLEED AIR INFLOW and DEFOG

Question 15

The RADALT is only active when the aircraft is below ____ ft, bank angle <__ degrees and pitch angle <__ degrees

Answer 15

2500
30
15

Question 16

In which mode is the transponder operating in this screen?
<4503

Answer 16

Active without altitude reporting

Question 17

Where does the EDM get its electrical power from?

Answer 17

Gen bus or Bat bus

Question 18

Where is the chip detector located?

Answer 18

Reduction gearbox

Question 19

On the ground, what %Np values will be displayed in white text on a red background

Answer 19

60-82% and greater than 102%

Question 20

What is the torque/time limit with the oil temp in the amber range on the ground?

Answer 20

Less than 20% torque and only for 10 mins

Question 21

What is the purpose of the bobweight located on the forward control column?

Answer 21

Enhances control feedback and helps prevent overstressing of the airframe

Question 22

How does a hydraulic system failure affect flap operation?

Answer 22

Emergency system provides a once-time lowering of the flaps

Question 23

During the ejection process, movement of the seat is first initiated by…

Answer 23

Detonated gas pressure

Question 24

What indications will you get if the canopy is unlocked?

Answer 24

MASTER WARN annunciator, CANOPY CAS caution advisory and aural tone