General Knowledge Flashcards
(34 cards)
What are the after start procedures?
Check AI (cage) ATIS Set CDI, HDG BUG, QNH Check coms 1 & 2 Check transponder 1200 GND, flight ID Stby ATIS 281
What are the before taxi procedures?
Canopy latched
Oil temp above 24 degrees
Coms 2 ops ramp out call
What is the maximun power setting for taxi?
1500 RPM
What is the ideal speed for apron area and taxiways?
Apron area : 10kts
Taxiways : 20kts
What is the minimum power for turns more than 90 degrees?
800 RPM
Slipstream effect:
When power increase, yaw left or right?
Left
What is the departure altitude from JAD airport to training area?
1000 ft AMSL
When do we climb to 1500ft AMSL?
At Lake Thomson
When approaching training area, what is the height we should remain under before we reach SOUTH of water ski park?
2500ft AMSL
What is SCAP?
Smooth
Continuous
Axis
Proportional
At full throt, on GND, MAP is at 27-28 inches, but at 4500ft AMSL, what is the MAP at?
25 inches
What are the limiting speeds for half flaps & full flaps?
/
Before touching flaps, what should i say to QFI?
Half flaps : 100 KIAS
Full flaps : 91 KIAS
/
“Speed xx kts, flaps to half/full sir”
Which has a greater effect on the plane?
When flaps from UP - HALF or HALF - FULL?
Explain
UP - HALF
(significant pitch up and balloon, airspeed decrease)
HALF - FULL
(slight pitch up and balloon, airspeed decrease)
Which has a greater effect on the plane?
When flaps from FULL - HALF or HALF - UP?
Explain
FULL - HALF
(slight pitch down and sink, airspeed increase)
HALF - UP
(significant pitch down and sink, airspeed increase)
What is the straight and level motto?
PAP
Power + attitude = performance
1) Fast cruise power setting
2) Slow cruise power setting
3) Half flaps power setting
?
1) 25/26 , 3” BH , 120kts
2) 18/26 , 1” BH , 90 kts
3) 20/26 , 3” BH , 90 kts
What is CCHT?
Change
Check
Hold
Trim
Accelerating procedures?
From SC - FC
PATAP : Power (full power) Attitude (lower) Trim Anticipate (110kts) Power (25/26)
Decelerating procedures?
From FC - SC
PATAP : Power (15/26) Attitude (raise) Trim Anticipate (95kts) Power (18/26)
What are the lookout weaves we need to do?
- Every 1000ft, do at least a 30 degrees heading change
- Every 500ft do T’s & P’s (eg. 1500ft, 2500ft)
Do we have to do T’s & P’s check on descent?
No
Before we do a MLT/ turn, what do we have to check?
Check plane is properly trimmed
VR selected
For a SC MLT, what do we have to do before we commence the MLT?
Check plan properly trimmed
VR selected
Increase power 1” - 2” MAP (to maintain 90kts)
For MLTs, when we are doing our CCH, what do we always correct first?
AOB