Midterm - Kahoot

Question 1

What two factors should be considered when choosing a dynamic routing protocol?

Answer 1

Scalability.

Knowledge level of the protocol.

Question 2

Minimum # of routers in an area before considering a multi-area design.

Answer 2

50

Question 3

BGP considered a path vector protocol? [T/F]

Answer 3

True

Question 4

EIGRP ipv6 multi-cast address.

Answer 4

ff02::A

Question 5

Which ipv6 link allows neighbours to send neighbour information to each other?

Answer 5

Link-Local

Question 6

Broadcast is not supported by ipv6? [T/F]

Answer 6

True

Question 7

EIGRP uses which feature to determine best path selection?

Answer 7

DUAL

Question 8

Summarization is used to help expand the routing table? [T/F]

Answer 8

False

Question 9

How long will an EIGRP router wait before placing a route into an SIA state?

Answer 9

180

Question 10

EIGRP stub- _________ to announce only the connected networks.

Answer 10

Connected

Question 11

EIGRP for ipv6 uses an ipv4 (32 bit address) as the router id. [T/F]

Answer 11

True

Question 12

In OSPF which options must match on both routers for a neighbourship to begin?

Answer 12

Hello/Dead interval
Stub Flag
Area ID

Question 13

OSPF in a broadcast network uses the following to control LSA updates:

Answer 13

Designated Router

Backup Designated Router

Question 14

OSPF uses multi-cast address 224.0.0.6 to reach the Designated Router. [T/F]

Answer 14

True

Question 15

OSPF uses the following to calculate cost to a destination network:

Answer 15

Bandwidth

Question 16

OSPFv3 is ipv6 - therefore ipv4 prefixes are announced within the ipv6 OSPFv3 update. [T/F]

Answer 16

True

Question 17

OSPF and OSPFv3 go through a total of 5 states before forming an adjacecy. [T/F]

Answer 17

False

Question 18

What is the default interface priority in OSPF?

Answer 18

1

Question 19

Which type of LSA is generated by a DR and a BDR?

Answer 19

LSA type 2

Question 20

LSA type 5 is generated by:

Answer 20

ASBR

Question 21

Prefx-lists are advance access lists. [T/F]

Answer 21

True

Question 22

Redistribution is always done in the inbound direction. [T/F]

Answer 22

False

Question 23

Does the routing table on the router performing redistribution change?

Answer 23

No

Question 24

Which redistribution strategies have a high probability of routing loops?

Answer 24

Multipoint
Two-Way Redistribution
One-Way Redistribution

Question 25

What is the default seed metric for an OSPF route that is redistributed into an EIGRP AS?

Answer 25

Infinity

Question 26

Administrative distance of internal EIGRP.

Answer 26

90

Question 27

Administrative distance of a connected route is 1. [T/F]

Answer 27

False

Question 28

Administrative distance of OSPF.

Answer 28

110

Question 29

EIGRP learned routes are identified as:

Answer 29

D

Question 30

OSPF LSA type 3 learned routes are identified as:

Answer 30

O IA (Inter-Area)

Question 31

OSPF LSA type 5 learned routes are identified as:

Answer 31

O E2

Question 32

ASBR announces our default route as OSPF type 5 LSA 0-E1. [T/F]

Answer 32

False

Question 33

Route-maps are like if/else statements. [T/F]

Answer 33

True

Question 34

Access-lists can be used to ____?

Answer 34

Match a set of ip prefix. Filter inbound/outbound on an interface. IGP updates.

Question 35

Route-maps are used to manipulate prefixes. [T/F]

Answer 35

True