Open Book 3

Question 0

On the APX 118/123 what is indicated by the green LED not being Lit?

Answer 0

All of the above

Question 1

The (VV) term shall be manually set to _____ to minimize roll in / roll out signals.

Answer 1

490

Question 2

The low battery fault LED (red) illuminates when:

Answer 2

Internal crypto back up battery voltage is low.

Question 3

What altitude is sad performance check conducted?

Answer 3

500ft

Question 4

If this switch is held for less than 8 sec all red keys stored in the transponder will be erased.

Answer 4

RT zeroize switch

Question 5

What is the recommended action for an aims 8.8 bit failure?

Answer 5

Check connections between AEU and ATU

Question 6

What is the bandpass index with lower bandpass 0.08 selected with gamma FS set in sense 1?

Answer 6

36

Question 7

To accomplish self test on the ASQ 81 mad system utilizing the TST function, the amplifier power supply mode selector must be in the ______ position.

Answer 7

Normal/1

Question 8

The ________ provides the controls necessary for computerized compensation procedures using outputs of the magnetic field computer.

Answer 8

Magnetic field indicator

Question 9

The FMC is a non-volatile flash cache III solid state ____GB recording medium.

Answer 9

64

Question 10

On the ASX-6 DVR what is the maximum recording time utilizing one channel?

Answer 10

40 hours

Question 11

What Nav aid is used during radar stabilization checks?

Answer 11

Both INS 1 and INS 2

Question 12

If the selected INS is in ATT REF, the radar must be in _______ and ________ (APS-115 only)

Answer 12

Heading stab/ off line

Question 13

What is the rate in which the digital counters (9TC) move when rate 4 is selected?

Answer 13

170 digits per 10 sec

Question 14

TEST enables the ______ test set to locally interrogate the transponder while enabling the transponder to reply.

Answer 14

TS-1843 / APX

Question 15

The gps amplifier accepts the signals from the GPS antenna assembly and provides a filtered and amplified output directly to the GPS receiver which is contained in the _______ as an SRA.

Answer 15

REP

Question 16

When online is selected on the ASA-69, the RIU is slaved to inputs from the ________.

Answer 16

Non-acoustic operator key set.

Question 17

What is the frequency of the APS-115 receiver transmitter?

Answer 17

8500-9600 MHz

Question 18

To achieve maximum detection range, consistent with local geological noise, which of the following procedures should be utilized once the aircraft is at MAD operating altitude?

Answer 18

Adjust FS switch so that noise indication on the RO-32 chart is between 1 and 2 major divisions.

Question 19

There are _____ identical and interchangeable C/D band spiral antennas in each wingtip.

Answer 19

4

Question 20

What is the proper way to secure power on the Antenna elevation parking control only?

Answer 20

Pull APP DC breaker

Question 21

When performing an OFOM with the ASQ 81, the maximum single component is _______ gamma.

Answer 21

.3

Question 22

Which component of the ALR 95 (V2) provides ESM audio alerts?

Answer 22

SP-160 (RDP)

Question 23

The GPS fill port is required to remotely load GPS crypto keys. This is necessary to maintain ________ as required for SAR mode.

Answer 23

Precise positioning service.

Question 24

On the IRDS missile status panel, assignment of the AIMS to any mode except SS3 will prevent stations other than the assigned station from taking control of AIMS.

Answer 24

True

Question 25

While using EON under normal conditions, which optical filter is best for AIMS?

Answer 25

Visible

Question 26

The radar stabilization check is used to determine:

Answer 26

All of the above

Question 27

When the AIMS steering mode is AVT auto track, rate aid, sector scan, or forward depression of this switch will put the aims into manual mode.

Answer 27

Bore sight switch

Question 28

The IFF caution light illuminates for _______ seconds each time the transponder is turned on indicating proper keying and acceptance of mode 4 codes.

Answer 28

3 to 6 seconds

Question 29

What is the maximum number of comics?

Answer 29

24

Question 30

When annotating aircraft maneuvers on the mad recorder, the symbol "r" would mean?

Answer 30

Nose right or right wing down

Question 31

Annotation on the RO-32 with the symbol (-) indicates what?

Answer 31

Roll +/- 10

Question 32

If the FOM exceeds ______, a system discrepancy is indicated and should be investigated.

Answer 32

1.25

Question 33

What is the priority of a sensor fly to point?

Answer 33

12

Question 34

The center white of each SAR field of wedge represents the sweet spot and shall be a function of the aircraft altitude and be equal to the distance defined by _______ degree radar tilt angle.

Answer 34

10

Question 35

When AIMs is powered up and placed in normal mode after the TMS has been initialized, or when a TMS recovery from disk is performed, there may be a delay of up to______ to ______ min for AIMs related pep functions to be avail;

Answer 35

2,3

Question 36

What is the size of your Primary tactical window?

Answer 36

1024 x 1024 pixels

Question 37

The _____ communicates control and status information to the rsci, rscmp, and VCU via the 1553 internal bus.

Answer 37

Rsc

Question 38

During the EMCON checklist, the SS3 is responsible for securing what equipment?

Answer 38

Radar, mad, interrogator/SIF

Question 39

On the IRDS control panel the not ready light should illuminate within ________ seconds of system turn on. And extinguish within _____ min.

Answer 39

30 sec, 12 min

Question 40

The IR sensor provides ______ optical fields of view?

Answer 40

4

Question 41

With the AIMs turret Uncommanded movements may continue for 20 sec if forward is selected and ______ if stow is selected.

Answer 41

45

Question 42

The GPS can be keyed while the radar system is still initializing, however, the _________ alert will not extinguish until initialization has been completed.

Answer 42

GPS unkeyed

Question 43

What is the function of the digital to digital converter?

Answer 43

Interface between central computer and ACMC.

Question 44

The _______ function accommodates the electrical interface requirements for control and status signals between the rep, other WRAs in the radar system, and other systems in the aircraft.

Answer 44

REP radar interface.

Question 45

In this mode the tape is moved every . 5 sec to prevent damage.

Answer 45

Standby

Question 46

If the over temp sensor activates and shuts down the display (chrd) the sensor may be over ridden and the display powered on by :

Answer 46

Simultaneously pressing the "brightness -" and "contrast +"

Question 47

The ank contains how many keys?

Answer 47

84

Question 48

The ASX-4 stow light illuminates when the turret is in the stow position ________ degrees right and _____ degrees up.

Answer 48

90,90

Question 49

The ALT position on the DCI will allow what positions to monitor each other?

Answer 49

NAV comm and Tacco