Oral Bank - AIR SYSTEMS Flashcards

(30 cards)

1
Q

When does the equipment cooling system configure for flight?

A

One or more engines on each wing is operating

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

On the ground, when is warm equipment cooling air ducted overboard? (3)

A
  • Engines not operating
  • Equip cooling selector in NORM
  • Ambient temperature moderate or high
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Equipment cooling provides cooling air for what compartment and systems? (2)

A
  • Flight deck equipment
  • Electrical and Equipment racks (E & E)
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

How can you manually configure the equipment cooling system for flight?

A

Equipment Cooling Selector to STBY

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is the function of the Lower Lobe Cargo Conditioned Air Flow Rate selector?

A

Provides conditioned air to forward and aft cargo lobe

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What happens if a pack temperature controller (PTC) detects a fault in a pack channel?

A

Control of the respective pack switches to the other PTC

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

How many pack temperature controllers (PTC) are provided?

A

Two (A and B)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

On the 747-8 with Main Deck and FWD/AFT lower lobe temp selector in the OFF position, what is the temperature zone target?

A

20 degrees C (68F)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

747-8, the Nitrogen Generation System coverts bleed air to nitrogen enriched air for what purpose?

A

Reduce flammability of center wing tank fuel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

On the 747-8, what does the alternate ventilation system provide with Pack 1+2+3 shutdown and the airplane depressurised?

A

Outside air to the Flight Deck

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

On the 747-8, what position are the MAIN DECK FWD and AFT TEMP selectors normally placed in during preflight?

A

Off

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

On the 747-8, what position is the LOWER LOBE AFT CARGO HT selectors normally placed in during preflight?

A

Low

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

On the 747-8, the TEMP DEV CGO advisory message HI or LO respectively indicate?

A

HI: 5 degrees C higher than selected temp (9F)
LO: 5 degrees C high than selected temp (9F)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

The 747-8 Lower Lobe Aft Cargo Heat Selector regulates the temperature control valve to maintain at least __________ in LOW position and ___________ in HIGH position?

A

LOW: 4 degrees C (40F)
HIGH: 10 degrees C (50F)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

The 747-8 ECS Left and Right trim air is provided to which temperature zones?

A

LEFT: Flight Deck, Upper Deck, Crew Rest, Aft Main Deck
RIGHT: Forward Main Deck, Forward Lower Lobe, Aft Lower Lobe

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

When is descent mode, will the cabin altitude controllers program a positive or a negative pressurisation at touchdown?

A

Small positive pressure

17
Q

What action would allow manual operation of the pressurisation system?

A

Both Outflow Manual switches to ON

18
Q

When does the cabin altitude controller switch from controllers? (2)

A
  • Automatically selects A or B on alternate flights
  • If the other fails
19
Q

How many cabin altitude controllers are provided?

A

Two (A and B)

20
Q

How can you gain manual control of the landing altitude?

A

By pushing the LDG ALT switch

21
Q

What does the Zone System (SYS) Fault Light indicate? (3)

A
  • Temp zone duct overheat or zone temp controller fault has occured
  • Master trim air valve failed closed
  • Master trim air valve closed and pack air continues to flow
22
Q

Under what conditions would High Pressure (HP) air be used? (2)

A
  • Descent
  • Other low power setting operations
23
Q

How would you isolate a bleed air duct section in the event of a bleed duct leak? (2)

A
  • Close the respective isolation valve
  • Close the engine bleed air valves
24
Q

What does a bleed duct isolation (ISLN) VALVE light indicate?

A

Isolation valve disagrees with switch position

25
When bleed air pressure is available the Engine Bleed Air Switches control which valves by system logic? (3)
- PRV - HP Bleed Valve - Engine Bleed Air Valve
26
Describe the general function of pressure regulating valve (PRV)?
Prevents damage to ducting and equipment downstream by limiting bleed air pressure
27
Under what conditions would Intermediate Pressure (IP) air be used?
High power setting operations
28
With a right duct isolated, how will this affect the hydraulic systems? (2)
- Hydraulic demand pump 4 is turned off - No hydraulic system 3 and 4 reservoir pressure
29
With the EICAS message STARTER CUTOUT 1,2,3,4 show, will Nacelle anti-ice be available for the related engine?
No
30
With a right duct isolated, how will the affected leading edge flaps extend?
The right wing LEF operate electrically in secondary mode