Q&A

Question 1

When does the Master Caution light illuminate for a single/simple fault?

Answer 1

Master Caution Recall

Question 2

The PSU supplies oxygen, per seat row, for how many minutes?

Answer 2

12 minutes

Question 3

When do the overwing emergency exit doors locks engage?

Answer 3

A minimum of three of the four entry/service doors are closed, and either engine is running, and the aircraft air/ground logic indicates that the aircraft is in the air or both thrust levers are advanced.

Question 4

What is the function of the Electric Air Compressor?

Answer 4

This supplies pressurized air to the Potable Water Tank when the pneumatic system is insufficient and is powered by Main Bus number 1.

Question 5

With both the LED Landing lights ON and Taxi Light ON/AUTO the taxi light function is ______ by the landing light function.

Answer 5

with both the LED Landing and Taxi Light ON/AUTO the taxi light function is overridden by the landing light function

Question 6

Pressurization Panel: The AUTO FAIL (amber) light illuminates if any of the following conditions occur: (name one)

Answer 6

Loss of DC power or Controller fault or Outflow Valve control fault or Excessive differential pressure or Excessive rate of cabin pressure change or High cabin Altitude.

Question 7

The Wing Body Overheat (amber) light, when illuminated, indicates what?

Answer 7

an overheat has been detected

Question 8

Thrust must be limited to idle with the __________ light illuminated.

Answer 8

Dual Bleed

Question 9

What does a Bleed Trip Off light indicate?

Answer 9

excessively high bleed air Temperature (254⁰C) OR excessively high Pressure(220psi) and may be reset with the trip/reset button if conditions permit.

Question 10

The MAX pneumatic systems use ______ and _______ stage bleed air.

Answer 10

4th and 10th

Question 11

What are your indications when you receive a SELCAL? _______ and _________ .

Answer 11

SELCAL white light and Two-tone chime

Question 12

Which radio defaults to DATA on power up and at power down?

Answer 12

VHF 3

Question 13

The Radio Tuning Panel (RTP) displays __________ when the selected radio is not available.

Answer 13

FAIL- FAIL

Question 14

What does an illuminated Offside Tuning (white) Light indicate?

Answer 14

The radio normally associated with this panel is being tuned by another radio tuning panel, or the radio tuning panel is being used to tune a radio not normally associated with this radio tuning panel.

Question 15

On the MAX, where is the SELCAL light?

Answer 15

Just below the Mic selector, on the ACP.

Question 16

With the Ignition Select System at IGN R, what is the power source?

Answer 16

AC Standby Bus

Question 17

What will remove an amber ENG FAIL indication?

Answer 17

The engine recovers, the start lever is moved to CUTOFF, or the fire switch is pulled.

Question 18

What does the THRUST crew alert on the Engine Display indicate?

Answer 18

The associated engine thrust is more or less than the commanded thrust. THRUST is displayed in conjunction with the N1 command sector illuminating amber.

Question 19

The Thrust Mode Display (green) indicates R-TO. What mode is active? _____________________.

Answer 19

reduced takeoff

Question 20

In the MAX, how long should you wait after the APU GEN OFF BUS (blue) light extinguishes before the positioning the Battery Switch to OFF? (CW)

Answer 20

5 minutes

Question 21

During a FAULT/INOP test, the failure of the FAULT light to illuminate indicates _________.

Answer 21

the Fault Monitoring System is inoperative

Question 22

If the OVHT DET switch is positioned to A or B, the system operates as _______.

Answer 22

a single loop system

Question 23

Rotating an Engine Fire Switch in one direction ____________________.

Answer 23

electrically fires a squib, discharging the extinguisher into the related engine

Question 24

How long do we have fire suppression after the Cargo DISCH switch is pushed?

Answer 24

195 minutes

Question 25

The MAX has how many wheel well fire detector loops?

Answer 25

Two

Question 26

The Fuel LOW (amber) Alert is displayed when the respective Main Tank fuel quantity is less than _________ for greater than _________.

Answer 26

2000 lbs 30 seconds

Question 27

Aside from a leak, what could cause a progressive fuel imbalance?

Answer 27

the Crossfeed Valve open, no Center Tank fuel feed, Main Tank Fuel Pumps operating within the normal pump output pressure tolerances

Question 28

Opening the Crossfeed valve inflight, ______________.

Answer 28

allows fuel from a main tank, with operating fuel pumps, to provide fuel to both engines

Question 29

IMBAL (amber) alert means the main tanks differ by more than ______ pounds.

Answer 29

1000

Question 30

The FUEL FLOW (amber) Alert is displayed when_______ on the MAX.

Answer 30

when the difference between actual engine fuel flow rate and the FMS expected fuel flow rate exceeds the predetermined FMC threshold value for 5 continuous minutes

Question 31

The COWL ANTI-ICE (amber) light illuminates due to

Answer 31

excessive pressure in the duct

Question 32

Which leading devices are on the Wing Anti-ice system? _________

Answer 32

Three inboard Leading Edge slats

Question 33

A TAI (amber) indication to the left of an N1 display on the Upper Display Unit indicates: __________________________________.

Answer 33

the Cowl Anti-Ice valve failed to move to the position selected by the ENG ANTI-ICE switch

Question 34

Positioning the WING ANTI-ICE switch to ON in flight______________?

Answer 34

opens both control valves and sets stall warning logic for icing conditions

Question 35

On the MAX, how is the engine core anti-ice controlled?

Answer 35

Automatically, by the EEC.

Question 36

With a TCAS Pitch Command on the PFD displayed, keep the aircraft symbol _______ the area indicated by the red lines.

Answer 36

outside

Question 37

If not previously commanded on, Predictive Windshear for takeoff automatically turns on by__________.

Answer 37

advancing thrust levers beyond 53 degrees

Question 38

The GPWS provides BANK ANGLE alert when the roll angle exceeds ___⁰, ___ ⁰, and ___ ⁰?

Answer 38

35 ⁰, 40 ⁰, and 45 ⁰

Question 39

Which button do I select on the radar panel to display turbulence?

Answer 39

WX+T

Question 40

The MAINT (amber) light, when illuminated, indicates _________.

Answer 40

that when a system fault exists that must be reviewed by Maintenance