Section 2 URE

Question 1

On the type III hydrant system, which filter separator control valve function will prevent the elements from bursting and allowing contaminated fuel downstream?

Answer 1

Maximum DP shutoff

Question 2

On the type III hydrant system, what will make the automatic bypass valve open and let fuel bypass the filter separator when receiving cross-country pipeline?

Answer 2

DP of 20 psi sensed across the receiving filter separator

Question 3

On the type III hydrant system, the ball float assembly for the high-level shutoff valve is located on an aboveground operating storage tank on the

Answer 3

Exterior of the tank at the required shut-off height

Question 4

If the tank outlet Manual valve on the type III hydrant system is open during an emergency stop situation, the

Answer 4

Horn will sound

Question 5

When the PRT on the type III hydrant system is 70 percent full, the

Answer 5

Switch assembly automatically turns on the pump

Question 6

How long will the fueling pumps on the type III hydrant system operate if the control circuit is not closed and what component closes the circuit?

Answer 6

5seconds; flow switch

Question 7

To what component is the DPT on the type III hydrant system connect?

Answer 7

Venturi

Question 8

Where does the type III hydrant system PIT sense atmospheric pressure?

Answer 8

Issue line

Question 9

How many differential pressure transmitters are installed on the issue line of the type III hydrant system with a refueling capability of more than 2400 gallons per minutes

Answer 9

Four

Question 10

On the type III hydrant system what size is the hydrant control valve that is designed for a flow rate of 600 gallons per minute

Answer 10

4 inches

Question 11

The back pressure control valve in the type III hydrant system will close at what hydrant loop flow rate?

Answer 11

600 gpm

Question 12

On the type III hydrant system how many DPTs are connected to the 4 inch return Venturi?

Answer 12

4

Question 13

What type III hydrant system component is flush mounted on the end wall of the pump control panel, is completely solid state with no moving parts and indicates an emergency is occurring?

Answer 13

Alarm annunciator

Question 14

Which condition will cause the vibrating horn to sound on the type III hydrant system?

Answer 14

System engine generator default

Question 15

The purpose of the lock out key used on the type III hydrant system is to

Answer 15

Transfer control from one microprocessor to the other

Question 16

How many days minimum can the battery in the type III hydrant system maintain the microprocessor’s memory

Answer 16

30

Question 17

On the type III hydrant system, the LED in the battery backup system in each microprocessor will indicate a problem at least how many days in advance before the battery becomes weak enough to jeopardize the integrity of the memory

Answer 17

3

Question 18

What is the rated capacity of the pumps on the type IV hydrant system?

Answer 18

600 gpm

Question 19

When using the type IV system how many aircraft depending on the type can be hot refueled simultaneously in about 8 to 12 minutes

Answer 19

Two

Question 20

How many tanks are used with the type IV hydrant system and how many gallons will each hold?

Answer 20

Four; 50,000

Question 21

On the type IV hydrant system How is fuel prevented from spilling onto the hot pad should a hose separate from the nozzle during a hot refueling operation?

Answer 21

A dry break coupler located inside the hose will close automatically.

Question 22

Since the type five hydrant system is not required to be manned when it is operated inspections are performed every

Answer 22

3 hours

Question 23

On the type five hydrant system what size are the stainless steel pantographs installed inside the hardened shelters

Answer 23

3 inches

Question 24

Who should be contacted if the DD form 250 bill of lading or contractor delivery ticket is not available upon arrival of the tank truck?

Answer 24

Quality assurance representative

Question 25

During a receipt operation Danger signs should be placed how far in front and rear of truck when offloading unsecure area

Answer 25

50 feet to the front and the rear

Question 26

The AF form 1231 is prepared to cover the 24 hour duty day that runs from

Answer 26

2400 to 2400

Question 27

In entry is required in column B (stick/meter before) and C (stick/meter after) on the AF form 1231 for products received by tank car or tank truck when

Answer 27

A discrepancy exists that Requires gauging

Question 28

An entry is required in columns J (time in) and K (time out) on the AF form 1231 for products received by

Answer 28

Tank truck

Question 29

On the type III hydrant system at what pressure will the control system start the lead pump when the system is in the automatic mode in an idle condition

Answer 29

60 PSI

Question 30

What to valves on the type III hydrant system bleed the pressure down to 70 pounds per square inch when the lead pumps stops

Answer 30

Pressure control and defuel/flush

Question 31

What will happen if the return venturi on the type III Hydrant system senses a flow rate of 700 gallons per minute for a continuous interval of 15 seconds when fuel is being pumped at a flow rate of 1200 gallons per minute

Answer 31

One pump will stop

Question 32

During type IV hydrant system operations who is responsible for positioning the aircraft on the hot pad

Answer 32

Hot refueling supervisor

Question 33

The fueling control valve on the type IV hydrant system is open to perform hot refueling operations by

Answer 33

Air pressure from the dead man control valve

Question 34

Who may approve leaving fuel units Engines running during fill stand operations

Answer 34

MAJCOM functional manager

Question 35

What form serves as a record for all issues from and returns to the bulk

Answer 35

DESC form 1233

Question 36

A separate DESC form 1233 may be maintained for each fill stand meter at the discretion of the

Answer 36

FMT

Question 37

When using the DESC form 1233 to record transfers draw a line though the words "unit no" in the issues and write

Answer 37

"TRF TO TK NO" in the space above

Question 38

Who is responsible for comparing the quantities transferred/received on an AF form 834 and entering the gain (loss) on the receipt form?

Answer 38

FSC

Question 39

What is the max flow rate of the r12 defuel pump?

Answer 39

300 gpm

Question 40

Which valve on the type III hydrant system will modulate open allowing the fuel to pass through when returning to the operating tanks during a defuel operation?

Answer 40

Back pressure control valve

Question 41

Who together with the FMT will ensure every effort is made to properly schedule the max use of hydrant systems to preclude flushing?

Answer 41

Operations and logistics groups.

Question 42

Type III, IV and V hydrant should be flushed

Answer 42

Monthly

Question 43

Fuels management and base CE/LFM personnel develop specific operating instructions for hydrant system flushing based on the

Answer 43

Type of system

Question 44

When flushing type III, IV and V hydrant systems when should a visual sample be drawn on the return line?

Answer 44

At the midpoint of flushing operations

Question 45

When emptying a mobile refueling unit into aboveground tanks, perform this operation

Answer 45

By using the off loading pumps

Question 46

When emptying through the bottom loading valve of a mobile refueling unit what must be activated until the fuel level drops below the float valve reservoir

Answer 46

Override button

Question 47

In what section of the DESC form 1233 are returns to bulk recorded?

Answer 47

Fueling unit summary

Question 48

Operation of the product recovery system and the water drain system will be constantly attended by a qualified fuels and/or

Answer 48

Water fuels maintenance technician

Question 49

Fuel/water mixtures from product recovery systems should be disposed of in accordance with

Answer 49

Local, state, and federal environmental laws and regulations

Question 50

What mesh screen is used in the type III hydrant system receiving strainer?

Answer 50

60