SY204

Question 1

The VHF transceiver has a separate radio for monitoring VHF Guard

Answer 1

False

Question 2

The UHF/VHF key is located on the PCL

Answer 2

True

Question 3

What is UHF Guard frequency?

Answer 3

243.00 Mhz

Question 4

How many UHF antennas does the T6 have?

Answer 4

2

Question 5

The UHF backup control unit is activated by __________?

Answer 5

turning the OFF/PUSH TEST knob clockwise

Question 6

Up to ____________ preset channels are allowed in the UHF backup control unit.

Answer 6

20

Question 7

The UHF backup control unit is located in __________?

Answer 7

the front cockpit only

Question 8

What are the two interphone modes?

Answer 8

HOT and COLD

Question 9

When in HOT mode __________?

Answer 9

both microphones are active

Question 10

The ground crew interphone headset jack is located ___________?

Answer 10

on the left side of the fuselage, below the avionics bay

Question 11

To adjust VHF radio volume __________?

Answer 11

rotate the VHF knob on the audio control panel

Question 12

The audio control panel is located in the front cockpit only?

Answer 12

False

Question 13

What effect will moving the bypass switch to the ALTN position have on the UHF radio?

Answer 13

The audio will be unamplified, raw audio.

Question 14

What are the buttons on the left side of the RMU?

Answer 14

Field select keys

Question 15

What will you see when a field select key has been pressed?

Answer 15

A rectangular cursor will appear in the field.

Question 16

Transfer switches are labeled with a ___________?

Answer 16

white diamond

Question 17

Pulling out the small tuning knob will allow you to change UHF frequency in __________ increments.

Answer 17

twenty-five kHz

Question 18

What indication is given when the RMU is on the preflight test page?

Answer 18

The letters “PFT” are shown in the top field

Question 19

If the RMU passes the preflight test it will display the preflight test page for 5 seconds, then return to the normal operating page.

Answer 19

True

Question 20

UHF radio information is displayed in the ________ field on the RMU display

Answer 20

first

Question 21

To toggle between active and standby frequencies on the UHF radio __________

Answer 21

press the transfer switch adjacent to the UHF field

Question 22

Pressing the MEM special function key will __________.

Answer 22

display the last used memory channel in the standby frequency

Question 23

What indication is shown on the RMU display when UHF Guard is turned on?

Answer 23

The word “GUARD”

Question 24

How many VHF NAV presets can be stored with the RMU?

Answer 24

10

Question 25

What does the DMEH button do?

Answer 25

Holds the current DME information while allowing use of another nav facility

Question 26

With the transponder mode set to STBY, what information is being transmitted?

Answer 26

None

Question 27

How many transponder codes can the RMU store in addition to the active code?

Answer 27

One

Question 28

VHF NAV volume control is provided through __________

Answer 28

the NAV knob on the audio control panel

Question 29

The ground crew interphone is activated ___________

Answer 29

when the battery switch in either cockpit is switched on

Question 30

If the RMU does not pass the preflight test, you may override the system by ________

Answer 30

pressing the key next to ACCEPT

Question 31

When in both mode, the UHF radio will ___________

Answer 31

monitor Guard and the active frequency and transmit on the active frequency

Question 32

UHF radio direct tuning is accomplished by ____________

Answer 32

holding down the appropriate transfer key for at least 3 seconds, then dialing in the new frequency

Question 33

The RMU allows storage of up to ________ UHF or VHF communications frequencies in memory channels

Answer 33

20

Question 34

To access the RMU special functions page for the selected system, __________

Answer 34

press the page special functions key

Question 35

The RMU preflight test in initiated by __________

Answer 35

applying power to the RMU

Question 36

What indication do you see when squelch is off

Answer 36

The letters "SQ" are displayed

Question 37

What indication will youy get on the RMU if the backup UHF radio control unit is in operation?

Answer 37

The word "REMOTE" will be displayed

Question 38

What is the main operational difference between the UHF radio and VHF radio?

Answer 38

The VHF radio doesn't monitor Guard frequency; you must dial it up manually

Question 39

With the transponder set to ALT, what information is being transmitted?

Answer 39

Aircraft altitude and transponder code