Brainscape's Knowledge GenomeTM


Top Flashcards (Certified)
All Flashcards

Leong-Tech > T.B. 127 - Inspection Cycles > Flashcards

T.B. 127 - Inspection Cycles Flashcards

(63 cards)

Start Studying
1
Q

Pressure Washers are dangerous and can cause an __________ Injury.

A

Injection

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Undercarriage cleaning creates RUNOFF with significant contamination and MUST be performed at a location were runoff is collected in a ___________.

A

Clarifier

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Who should provide CAV time for undercarriage cleaning?

A

Company Commanders

Battalion Commanders

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

If the company is available during Undercarriage cleaning, who SHALL monitor cleaning activities to prevent conditions that could delay a response?

A

Company Commander

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

After undercarriage cleaning while CAV, The Company Commander SHALL ensure that the apparatus is able to safely respond and that the Members are ______ and ready for a response prior to going Available.

A

Clean

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Members SHALL NOT use any equipment that creates an ________ spray of any flammable liquids such as ________.

A

Aerosol

Kerosene

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Approved products for Undercarriage Cleaning are available through SRS and listed in the catalog under: “_________, ______ ______”

A

“Degreaser, Gunk Type”

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

One of the most important aspects of cleaning the apparatus is the thorough visual and hands on ________.

A

Inspection

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The use of High Pressure Spray can force water into areas intended for Grease only. Members should AVOID directing High Pressure Spray at _______ _______.

A

Rubber Seals

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

In all cases where Power Washers are used, when should Lubrication be done?

No later than?

A

Same Day as cleaning

No later than the NEXT day.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Power Washing is NOT a replacement for the _____ ___ approach.

A

Hands On

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

The MOST significant damage to an apparatus from a Pressure Washer occurs when water is sprayed into what?

A

Electrical and Electronic Components

i.e. alternator, diodes, wiring connectors, engine control electronics

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Telltale signs of Abuse with Pressure Washers:

  1. ______ stripping
  2. Water in _____ areas
  3. ________ of softer materials
  4. Water in sealed _______ components
A
  1. Paint
  2. lube
  3. Erosion
  4. electrical
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

MOPs section 7/1-48.26 PROHIBITS station personnel from using Industrial _______ _________. Who is permitted to use them?

A

Steam Cleaners

S&M personnel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

“In most areas, too little lube is far ______ than too much..”

A

WORSE

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

When working UNDER the apparatus, Members should take all necessary precautions to protect themselves from:

  • Hot Surfaces
  • Sharp Objects
  • Contamination
  • __________ Hazards
A

Electrical

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

What TWO lubrication products are ONLY to be handled by the Shops?

A

Transmission Oil

Differential Oil

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

What are the THREE approved lubrication products that can be used by station personnel?

A

Chevron “Black Pearl” chassis grease
Engine oil 15-40
Aqualube for Fire Pumps

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

What is the MAXIMUM air pressure that can be used with Power Lube equipment?

A

60 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

When using Power Lube equipment, Excessive Pressure will permanently _______ seals.

A

distort

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

What should you do PRIOR to lubing a ZERK fitting to prevent forcing contaminants inside?

A

Wipe the fitting clean

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
22
Q

Any FAILURE of boots on TAK 4 Independent Suspension should be promptly reported to who?

A

S&M for repair or replacement

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
23
Q

When lubricating after pressure washing, grease should be FORCED OUT until the grease appears free of what?

A

Contaminants

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
24
Q

What are Members allowed to paint on the Undercarriage?

A

Bare Metal

but only when needed to protect from corrosion

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
25
Are Members allowed to Spray Paint any part of the apparatus?
NO | only S&M is allowed
26
How can a Member request Undercarriage painting by S&M during Annual Test?
through SRS
27
In addition to cleaning, preparation for INSPECTION should include a thorough pre-inspection based on the _______.
F-377
28
Inspection of the Apparatus should START with a review of the F-_____.
F-377
29
As the responsible member, the DRIVER should be familiar with the apparatus including the: 1. __________ cycle 2. __________ problems 3. Recent _______ 4. Maintenance
1. Maintenance cycle 2. Unresolved problems 3. Recent repairs 4. Maintenance
30
Signs of ______ ____ indicate movement of parts where connections are loose or cracks "work".
Liquid Rust
31
Scale or Paint loss can indicate chronic ______ loss.
Coolant
32
What are the SEVEN Forms of documentation that are reviewed for Heavy Apparatus during Bi-Monthly Inspection?
F-377 F-704, F-705 F-972, F-973, F-977, F-979
33
What are the TWO Forms of documentation that are reviewed during the Four-Month Undercarriage Inspection?
F-978 | F-978 B
34
What are the NINE Forms of documentation that are reviewed during BIENNIAL Inspection (formerly Annual).
F-377 F-704, F-705 F-972, F-973, F-977, F-978, F-978 B, F-979
35
Who schedules BIENNIAL Inspection and when does it occur?
BES Commander Even Batt. on Even Years, Odd Batt. on Odd Years
36
Who schedules Bi-Monthly Inspections and when do they occur?
Battalion Commander First 2 weeks of EVEN months.
37
What is the F-704?
Maintenance Record
38
What is the F-705?
Repair Record
39
In preparation for Bi-Monthly Inspection, Captains should ensure Preventative Maintenance, Equipment Checks, Lubrication, and Repairs are properly recorded by reviewing what FOUR forms with the Drivers?
F-377 F-704, F-705 F-973
40
Patient Care Equipment SHALL be wiped down with an alcohol or __% bleach based Disinfectant after each _______ ________.
10% Patient Contact
41
SCBA Bi-Monthly Inspection Guide: Facemasks should be CLEAN and DRY and should not have excessive _________ on the lens.
Scratches
42
INSPECTION STANDARD: Apparatus undercarriage is to be clean enough to facilitate a Safety _________ .
Inspection
43
Undercarriage Inspection Guide (4 month Interval): Excessive amounts of _________ SHALL have been REMOVED and the Apparatus should appear clean.
Lubrication
44
Undercarriage Inspection Guide (4 month Interval): The Inspecting Officer SHALL check for areas where ______ is damaged and/or missing. The Officer should determine the importance of re-painting to protect the apparatus from ___________ and ______ .
Paint Deterioration Rust
45
Undercarriage Inspection Guide (4 month Interval): Re-Painting or touch up SHALL be requested as a Repair in _____ .
S.R.S.
46
Undercarriage Inspection Guide (4 month Interval): The Officer should check that NO _________ has been done that could be DETRIMENTAL to the operation of the apparatus or cause excessive difficulty during repairs such as __________ of: - Brake Slide Pins - Cooling Fins - Electronic Components - Electrical Wiring - Lubrication Fittings (Zerks) - Hoses - Belts
Painting Painting
47
Undercarriage Inspection Guide (4 month Interval): The Apparatus SHOULD be lubricated __________ after cleaning, and in no case later than the _____ day.
Immediately Next
48
Undercarriage Inspection Guide (4 month Interval): Inspecting Officers should check for Frame _______ (Particularly where Frame Rails are cut to accommodate _______ mounting), Leaf Spring cracks, excessive wear to Brake Rotors and Pads, and Air Tanks that have not been _______.
Cracks Engine drained
49
Undercarriage Inspection Guide (4 month Interval): Where are Damaged Grease Seals common?
Tiller Axle Kingpins
50
Undercarriage Inspection Guide (4 month Interval): Check for any HANGING, LOOSE, or UNSECURED _________ as well as any leaks
Wiring
51
Undercarriage Inspection Guide (4 month Interval): TAK 4 (Independent Front Suspension): Members SHALL NOT ____ the area protected by the boots, but should promptly report any HOLES or TEARS in these boots.
Lube
52
Undercarriage Inspection Guide (4 month Interval): Engine: Check BOTTOM for ______ and ____________ .
Leaks Corrosion
53
Undercarriage Inspection Guide (4 month Interval): Check the condition of ROTORS for cracks and _________ .
Scoring
54
Undercarriage Inspection Guide (4 month Interval): Check for Leaks: In general, leaks are NOT considered significant by S&M unless there is ___________ Fluid Loss.
Measurable
55
Undercarriage Inspection Guide (4 month Interval): Check Engine Oil for what FOUR things? 1. _______ 2. ______ 3. ______ 4. _______
L.O.A.F. Level Odor Appearance Feel
56
Undercarriage Inspection Guide (4 month Interval): Check BATTERIES for Corrosion, Signs of _________, Cable Wear, and Cracks.
Leakage
57
Undercarriage Inspection Guide (4 month Interval): Inspecting Officers should check the YARD areas to ensure that apparatus undercarriage cleaning is NOT performed in appropriate areas, particularly areas to do not have a _________ .
Clarifier
58
Undercarriage Inspection Guide (4 month Interval): What FIVE forms are required?
F - 972 Daily Pre Trip F - 977 Apparatus Inspection Checklis F - 978A Undercarriage Inspection Checklist F - 978B Undercarriage Inspection Report F - 979 SCBA Inspection
59
Generally, apparatus is brought to the SHOPS under what FIVE Conditions? 1. _____________ 2. ____________ 3. _____________ 4. _____________ 5. ____________
``` Annual Test Scheduled Repairs Unscheduled (Emergency) Repairs Routine Lubrication Accident Repairs ```
60
For ANNUAL TEST, Aerial Ladders SHALL be Cleaned and Lubricated approximately ____ weeks prior to the Annual Test.
2 weeks
61
What FIVE items need to accompany the Aerial Ladder Truck for ANNUAL TEST? 1. _________ 2. _________ 3. __________ 4. __________ 5. __________
``` 978-B Logbook Ladders SCBA Facepieces Hydraulic Rescue Tools ```
62
What is the Maximum speed in MTA Yards?
8 mph
63
In MTA Yards, What must be WORN at ALL TIMES and what SHALL LAFD members wear?
Reflective Safety Vest Brush Jacket

Leong-Tech (17 decks)

Brainscape helps you reach your goals faster, through stronger study habits.
© 2025 Bold Learning Solutions. Terms and Conditions