Warnings

Question 0

BAT DISCH

and activated warning gong

Answer 0

1. DC VOLTS, GEN AMPS and BAT AMPS - CHECK
2. Electrical consumption - Reduce to save battery
3. LAND ASA PRACTICABLE

Question 1

BAT TEMP

and activated warning gong

Answer 1

1. BAT MASTR sw. -“OFF”
2. “LAND ASAP”
3. Engine shutdown
4. Visual inspection of battery
   If no overheating singn
5. Start-up
6. BAT MSTR sw -OFF
7. LAND ASA PRACTICABLE

Question 2

FIRE

and activated warning bell

Answer 2

1. “OEI” flight condition
2. “Respective EMER OFF sw - Open guard, press, release”
   Engine cut off, ACTIVE illuminate / F VALVE CL on cad
3. “Affected engine. - Ident”
4. ” Single eng emer shutdown”

If warning off
5. “LAND ASAP”

If warning ON
5. “LAND IMMEDIATELY”

Question 3

LIMIT

and warning GONG

Answer 3

One of the limits is exceeded:
Tq, TOT, N1, MM, OEI (30” or 2’) TOP time limit
Reduce the respective parameter

Question 4

LOW FUEL 1 and / or 2

+ warning GONG

Answer 4

1. Fuel qty. - Check
   If positive
2. Both fuel XFER pump sw. - Check ON
3. Both fuel XFER pump cb. - Check IN

If LOW FUEL remain ON

4. Air cond
5. Bleed Air. - switch off ( if OAT>5c)
6. “LAND within 10min”

WARNING: LOW FUEL overrules the fuel qty indication

Question 5

ROTOR RPM
Low: Nro 97% or less. - Steady light / Intermitent low tone 800hz
High: Nro >106%. - Flashing light / Warning GONG
> 112%. - Flashing light / Continuous high tone 2400hz

Answer 5

1. ” Rotor RPM indicator. - Check “
2. ” Collective lever. - Adjust as necessary

If in addition Nro 10% to keep N2 and RPM matched

Question 6

XMSN
OIL P

And warning GONG
and both XMSN OIL P caution on CAD

Answer 6

” LAND ASAP “

Reduce pwr as much as possible
Vy in level flight
MGB dry run > 25 min

Minimum. 0.5 bar
Continuous. 0.5 - 7.8 bar
Caution range 7.8 - 10 bar