Safety Rules (Band Saw) Flashcards

1
Q

Why should you never back out of curved cuts while the machine is still running.

A

As this results in the blade coming off.( You must wait until blade comes to a complete stop)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Where should you make cuts

A

You should make cuts on the waste-side of the line

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

When can you operate

A

You can only operate with the instructors permission. And after you received instruction

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

always wear what or have your hair in what state

A

Never wear jewelry,secure loose colthes and confine/tie hair back

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

You should always maintain what when working with a blade

A

You should maintain a well balanced position and feed into the blade firmly, but without pushing too hard

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

what are three Never’s

A
  1. Never start the machine with stock touching the blade.
  2. Never reach under the table.
  3. Never perform layout or setup on the table
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Turn of a machine when:

A

When you’re finished cutting,before adjusting or changing set-ups,or when making repairs.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Turn machine off and disconnect it before:

A

installing or removing acessories

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What do you do when blade breaks

A

When it breaks stop the saw, leave stock where it is, unplug the saw and report the incident to the teacher.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Always use (PPE).

A

Personal protective equipment and proper eye protection.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When using a band saw keep what in place

A

Keep safety guard in place

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What should the upper guide clear stock be.

A

It should be about 6mm (1/4).

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Make what cuts gradually

A

curved cuts

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Use relief cuts for:

A

Tight radius curves

How well did you know this?
1
Not at all
2
3
4
5
Perfectly