DOP+GEN Flashcards

1
Q

Who is responsible for entraining and detraining special needs passengers?

A

The driver

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Where are the primary doors on an X’trapolis and comeng?

A

Doors 1 & 6

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Where are the leading doors on a Siemens?

A

Doors 1 & 4

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Where are the secondary doors on a X’trapolis and comeng?

A

Leading Motor doors 2 & 5

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Where are the secondary doors on a Siemens?

A

Leading Centre Motor doors 1 & 4

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What must be done if helping a passenger with special needs from the secondary doors, or when you are more than 3m from the cab?

A

Full cab unattended procedure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What must be done when helping a passenger with special needs from the primary doors, or from within 3m away from the cab?

A

Modified cab unattended procedure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What do you do if the ramp is defective/unusable?

A

Exchange it with the ramp from the CM, log a TMM for the damaged ramp

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is a near miss?

A

A situation where the driver has to apply normal or emergency brake to avoid collision with an obstruction

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the procedure for a near miss?

A

Brake into emergency and bring train to a stop
“Am I ok to continue?”
TEC/REC to controller
If not ok, request relief
If ok, continue at reduced speed
At FSS, if not ok DAO will cover shift
Submit incident report

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What can a driver do if met with unruly passengers?

A

Get to safe place
Contact train control (TEC/REC)
Provide details about offenders

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What is the procedure for an incident involving dangerous goods?

A

REC call
TDN, origin/destination, location
Nature of emergency
Emergency response required (HAZCHEM codes)
ID additional hazards

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What happens when you isolate a comeng from the overhead power lines?

A

Pantographs are lowered
doors open

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What happens when you isolate an X’Trap/Siemens from the overhead power lines?

A

Pantographs are lowered
110vDC is still active

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What is the role of a PD?

A

Audit drivers
Assess trainees
Provide assistance with faults
On standby via 24 hour helpdesk

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What are the driver requirements before signing on?

A

Be fit for work
Be on time/in the right location
Be wearing uniform and appropriate uniform
Ensure roster changes and relevant notices are adhered to

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

How can a driver sign on if metro go is unavailable?

A

Call the DAO and State:
Name
employee no
Sign on time
Shift number
Any other necessary details

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

What is the drivers duty of care?

A

Safety to:
Themselves
The public
Their colleagues

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

What legislation must drivers comply with for duty of care?

A

OHS act 2004
Transport act (section 29)
1994 book of rules and operating procedures

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

What must you do when you are being relieved?

A

Stop at the correct position
ID the relief driver
Advise the relief driver of any faults/defects that might affect running

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

Who do you contact if no relief driver is present?

A

The DAO

22
Q

What do you do if you are the relief driver?

A

Be in correct position and on time
Inspect any TMM/cab notices
Insert the new TDN and prep the DTRS

23
Q

What may you encounter when running empty stock movements?

A

Restrictive signals
Unaware pedestrians and vehicles
Loss of concentration

24
Q

What is the definition of a special needs/disabled person?

A

A person who due to age, disability, illness or pregnancy has special requirements

25
Q

What is the procedure for a driver when a train is going out of service?

A

Make appropriate PA calls
Use auto announcements
Check CCTV for remaining passengers
Close doors

26
Q

What is the procedure for station staff when a train is going out of service?

A

Make on platform announcements
Use auto announcements
Check CCTV for passengers
Give “all right” hand signal
Close doors

27
Q

What are the steps for stopping at a signal at “danger?”

A

Stop and keep brakes applied
Switch marker lights to white
Place reverser to off/neutral

28
Q

What is the departure sequence?

A

STDS:
Signal - check signal clearance
Time - check departure time
Departure checks
Second look - check signal again

29
Q

Where are white departure lights located?

A

Flinders street platform 14
Showgrounds (up)
Flemington racecourse platforms 1&2

30
Q

What does an off departure indicator light mean?

A

Train must not depart, passengers not clear/ready

31
Q

What does a departure light on and steady mean?

A

Passenger requirements are complete and train may depart (requires signal clearance)

32
Q

What hat you do if the departure lights change from steady to flashing?

A

Driver must make an emergency stop, and remain until safe to depart and given clearance (departure light or hand signal)

33
Q

What is the procedure for stopping short at a platform?

A

-Do not open doors
-Make announcement to passengers
-Make sure train is clear
-Sound long whistle
-Move train to the stopping mark
-Report to train controller, fill in incident report

34
Q

How does a driver secure the cab when assisting a special needs passenger when being relieved at the opposite end?

A

Comeng - Place brake into emergency
Siemens/Xtrap - press emergency stop button
Until cab is isolated

35
Q

When may you detrain passengers?

A
  • If it is safer to be off the train
  • if the train cannot be moved to a platform within 30 minutes (outside MURL)
  • if the the train cannot be moved to a station within 15 minutes (inside MURL)
36
Q

Who manages the transposal of drivers?

A

The DAO

37
Q

Who manages the transposal of trains?

A

Train controller

38
Q

When do you use a fault warning notice/sticker?

A

When a defect is found that impacts a train from safely operating

39
Q

How are drivers informed of altered running?

A

Via DTRS, or
physical authorisation given

40
Q

What is a CAN warning notice?

A

Condition Affecting the Network notice
- deals with an incident or condition affecting the safety of of operations on the network

41
Q

Do CAN notices give drivers authority to pass signals at danger?

A

NO

42
Q

What are the bell codes for cab to cab communication?

A

1 ring - attention
2 rings - proceed
3 rings - reverse
4 rings - call other cab to front of train
Series of rings - emergency stop

43
Q

Which colour passes are allowed in the cab?

A

Purple, yellow, green, blue, yellow/red

44
Q

When can a driver refuse a cab pass?

A

If they believe that the holder will compromise cab safety

45
Q

What’s the the 4 fault categories that drivers use?

A

Critical fault
Serious fault
Maintenance fault
Remarshalled fault

46
Q

What is a critical fault?

A

A fault where the trains integrity level or safety equipment is not functioning correctly.
Trains with this fault level must not enter service, or be removed from service ASAP

47
Q

What is a serious fault?

A

A fault where the trains integrity or safety is not affected
Trains with this level of fault may enter or remain in service, but should be removed when practical

48
Q

What are the serious fault sub categories?

A

SERIOUS PRIORITY - higher priority to be removed from service
SERIOUS RETURN RUN - fault is in leading cab, can be driven to its current destination
SERIOUS END RUN - fault in trailing cab, can be driven from the leading cab as far as possible

49
Q

What is a maintenance fault?

A

A fault that does not prevent the train from entering or remaining in service

50
Q

What information is needed for a train Malfunction message?

A

TDN
Train time, destination and origin
Affected carriage number
Details of defective equipment
Any equipment isolated

51
Q

What is a Fault Warning Notice?

A

A warning that is used when isolated/defective equipment affects the operation of vital safety equipment of the train

52
Q

Where are FWN and FWNS placed?

A

FWN in leading and trailing cabs
FWNS on or above the speedometer