15.1.9 Perform Flight Controls System Operations and Procedures

Question 1

Which hydraulic system powers the flaps and slats?

Answer 1

Center system only

Question 2

What is the function of the cutout position of the stabilizer cutout switches?

Answer 2

Shuts off respective left or center hydraulic system power to the related stabilizer trim control module

Question 3

In the normal mode, all leading edge slats move to the midrange position when the flap lever is moved to:

Answer 3

Flaps 1

Question 4

An aileron lockout control system locks out which ailerons?

Answer 4

The outboard ailerons at high speeds

Question 5

The SPEEDBRAKES light illuminates if speed brakes are extended and either:

Answer 5

• Radio altitude is 800’ or below, or

- Flaps are in landing position

Question 6

What does the STAB TRIM light on the overhead panel indicate?

Answer 6

Stab trim rate is ½ the normal control wheel stabilizer trim switch rate

Question 7

Which hydraulic systems power the Horizontal Stabilizer Trim?

Answer 7

Two hydraulic actuators (L & C hydraulic system)

Question 8

The takeoff flap positions are?

Answer 8

• 5°
• 15°
• 20°

Question 9

If the flap airspeed limit is exceeded, how does the flap load relief protect the flaps?

Answer 9

By automatically retracting flaps to 20°, when 25 or 30° is selected for landing

Question 10

Trailing edge flap asymmetry protection is provided in which mode of flap operation?

Answer 10

Primary mode only