ECAM SWITCHING PANEL Flashcards

1
Q

If the UPPER DISPLAY knob was switched to OFF what would occur?

A

The E/WD display would automatically transfer to the lower display

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

With the E/WD displayed on the lower screen, how else can you view SD information?

A

Press and hold the appropriate system button on the ECAM CONTROL panel you wish to view

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

How long will this information be available?

A

30 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What does the ALL pb do?

A
  • Displays ALL the system pages successively in 1-second intervals when held down
  • Release the pb to maintain display of the selected page
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What does pressing the RCL pb?

A

• Allows you to recall any warning or caution messages that the activation of the CLR pb or flight phase inhibition
may have suppressed
• If held longer than 3 seconds, the E/WD will show any caution messages suppressed by the EMER CANC pb

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

If power fails to the ECAM CONTROL panel which buttons are still functional?

A
  • EMER CANC
  • ALL
  • CLR
  • STS
  • RCL
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What does the EMER CANC do?

A

• Cancels the current Level 1 or 2 cautions for the remainder of the flight
• Cancels the current Level 3 aural warning and Master Warning light for that occurrence,
but does not affect the ECAM message display

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What do you look for on the FHED check?

A
  • Fuel – fuel quantity, configuration, and balance
  • Hyd – hydraulic quantity
  • Eng – oil quantity above 12.5 quarts
  • Door – doors closed, slides armed, crew oxygen pressure
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What occurs when the T.O. CONFIG pb is pressed?

A
  • The system simulates the application of T.O. power and checks certain systems for proper configuration
  • A warning is displayed if a system is not configured properly
  • “TO CONFIG NORMAL” is displayed in the TO MEMO section if the configuration is correct
How well did you know this?
1
Not at all
2
3
4
5
Perfectly