Outer Burial Containers Flashcards

1
Q

A general term referring to any container which is designed for placement in the grave around the casket, including, but not limited to, containers commonly known as burial vaults, grave boxes, and grave liners.

A

Outer Burial Container

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

To support the weight of the earth over the grave. Any burial not accompanied by such a container is subject to eventual collaspe due to the weight of the earth crushing down on the unprotected casket.

  • The resulting “sunken” grave then presents potential groundskeeping and visitor safety concerns.
A

Primary Purpose of the Outer Burial Container

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

While these do not require the use of an outer burial container, most cemeteries, in the interest of minimizing maintenance and liability issues, will require either a burial vault or grave liner be used in conjunction with any interment.

A

State and Federal Law

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Forces that the outer burial container is subject to.

A

Loads

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q
  • Static
  • Differential
  • Dynamic
  • Impact
A

Four Load Types

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Comprised of the weight of the soil above the outer burial container, as well as the force exerted by the earth against the outer burial container’s sides and bottom. Also encompasses the forces resulting from cyclic freezing and thawing of the earth.

  • Actual weight value varies depending on soil composition and water content
  • Average weight of 18 inch thick covering of earth over an outer burial container is ~4,000lbs (2 tons)
A

Static Load

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Typically of short duration, can be quite heavy, as in the case when soil from a grave under excavation is placed on top of an existing grave.

  • Normally removed within a few days, at most
A

Differential Loads

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

One that varies in its intensity and is usually temporal in nature, such as the weight of a dump truck that might drive over the grave, or the force exerted by a backhoe parked above an existing grave while it excavates another grave nearby.

  • Increased over the last few decades (more machinery used today).
A

Dynamic Load

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Encountered by the outer burial container when a sudden and powerful application of force is introduced to the gravesite, as occurs when a large amount of fill-dirt is dumped onto the outer burial container as the grave is filled, when a mechanical tamper is utilized in filling the grave, or when a backhoe’s bucket is forcefully dropped on a grave.

  • Brief but can create a tremendous amount of stress in a concentrated area.
  • Can easily cause a nonreinforced burial container to fracture and eventually fail.
A

Impact Load

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

An outer enclosure which offers protection from the earth load as well as possessing sealing qualities.

  • May be constructed from concrete, metal, fiberglass, or plastic polymers.
A

Burial Vault

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

An outer enclosure which offers protection from the earth load without protection from the elements.

  • Most commonly formed from concrete, but may also be seen made from other materials.
A

Grave Liner

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

May vary substantially. The standard is 30 inches wide by 86 inches long.

  • Most manufacturers make sizes compatible with children’s cakets.
A

Outside Dimensions of Outer Burial Containers

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

A two-piece affair consisting of a bse and cap (or “cover”). May or may not be internally reinforced with smooth steel bar or rebar, and the interior i typically lined with a material designed to further strengthen the structure and to resist the entrance of water.

  • Many offer secondary reinforcement by incorporating welded wire fabric (wire mesh) within the vault’s component pieces.
A

Concrete Burial Vaults

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q
  • Polystyrene plastic
  • ABS (acrylonitrile butadiene styrene)
  • Various wrought metals (stainless steel, copper, or bronze)
A

Materials Used to Line Concrete Vaults

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

A very tough and resistant plastic.

A

ABS (Acrylonitrile Butadiene Styrene)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Placed within the base and cap of the concrete vault. When used, the metal linings are usually present in addition to this initial lining material.

A

Separate Synthetic Liners

17
Q

Used by some vault manufacturers a both a lining and an exterior coating. Does little to strengthen the vault structure itself, but does reduce the concrete’s permeability.

A

Asphalt

18
Q

As a result, specialized and expensive equipment is necessary to transport the vault from its place of manufacture to the cemetery and install it within the grave.

  • Most funeral homes choose to have these installed by a local vault dealer
    • In many instances this dealer will provide the cemetery “set-up” or casket lowering device, tent, and chairs.
A

Concrete Burial Vaults Weigh in Well Over 2,000lbs (1 ton)

19
Q

Used by nearly every concrete burial vault. A method of closure that utilizes an epoxy compound in conjunction with tongue-in-groove construction at the top edge and the lid of the vault.

  • Uses the weight of the vault cover and earth load to its advantage producing contact between the groove:
    • Within the vault cover
    • The sealing compound or epoxy
    • And the tongue
A

Top Seal Method of Closure

20
Q
  • Decorative: Concrete surface may be swirled, patterned, or coated wtih sand. Painted in a color complementary to the chosen casket. Non functional handles or embellishments such as nameplates, crucifixes, or military emblems.
  • Protective: A superficial coating of asphalt
  • Both decorative and protective: an external cladding of ABS or bronze.
A

Concrete Vault Exterior Finishing Treatments

21
Q
  • Available in a variety of metal types and thicknesses. Commonly 12 to 7 gauge.
  • Materials: steel (galvanized), stainless steel, and copper.
  • Many funeral homes choose to warehouse and service these themselves rather than subcontract
  • Consists of a shallow base upon which the casket rests, and a top or “dome” which covers the casket and rests on the perimeter of the base.
  • Employ the diving bell (air seal) principal
A

Metal Burial Vaults

22
Q

Steel that has been coated with zinc for increased resistance to rust.

A

Galvanized

23
Q

A method of closure that utilizes the air pressure created by placing the dome (A) of the vault onto the base (B) of the vault.

A

Air Seal (Diving Bell)

24
Q

Gives the unit exceptional load resistance, and its curved interior allows collected condensation to roll down the sides of the vault and back into the earth.

A

The Arched Dome of the Metal Burial Vault

25
Q

The top of an air seal burial vault which entraps air as it is put into position; it also supports the weight of the earth above.

A

Dome

26
Q
  • Painted
  • Powder coated
  • Natural metal
  • These finishes are usually covered with a protective clear coat
  • The handles found on these are functional
A

Metal Burial Vault Finishes

27
Q

Not as widely used as concrete or metal vaults. Most often constructed using the air seal principal, some feature the top seal method of closure.

  • Lightweight and possess an almost unlimited lifespan when placed in soil.
  • Can be stacked in a “nesting” arrangement
  • Easily stored and transported by funeral homes that choose to service their own vaults.
A

Fiberglass and Polymer Vaults

28
Q
  • Concrete- typically top seal
  • Metal- typically air seal
  • Double seal
  • Some fiberglass and polymer- gasket in addition to air seal method. Also use the top seal method.
A

Methods of Closure

29
Q

A method of closure that utilizes the principle of the air seal in conjunction with an epoxy material at the junction of the done and the base of the vault.

A

Double Seal

30
Q

Sole purpose is to support the weight of the earth covering the grave; it incorporates no provision for inhibiting the entrance of water or soil.

  • Most commonly constructed of concrete and, to a much lesser extent, wood.
A

Grave Liners

31
Q
  1. Grave box
  2. Sectional liner
A

Two Varieties of Grave Liners Most Prevalent

32
Q

An outer enclosure consisting of a body and a one or two piece lid.

  • Holes are frequently present in the base so that accumulated water and other fluids may drain away.
  • The holes will also allow easy encroachment of ground water should the surrounding water table rise.
A

Grave Box

33
Q

A grave liner consisting of six or eight slabs of unfinished concrete placed around the casket in the grave.

A

Concrete Sectional Liner