Pre Fader Split Studio B

Question 1

What is Pre Fader Split used for?

Answer 1

sends mic signal to the DAW after processing

Question 2

What is the basic signal flow for Pre Fader Split?

Answer 2

Mic Output -> Preamp -> Line Input -> Processing -> DAW -> Monitor Returns -> Fader -> Pan -> Mix A

Question 3

Where is the split in Pre Fader Split?

Answer 3

after processing

Question 4

How do you set up Pre Fader Split?

Answer 4

1. ) wake up channel select by pressing + and - together
2. ) press SELECT then ALL to select all channels
   - should be a green highlight around all channels in the TFT display
3. ) in CHANNEL IN, select MIC
4. ) in CHANNEL OUTPUT, select PRE FADER
5. ) in CHANNEL IN, select SPLIT
6. ) in BUS ROUTING, select MIX A
7. ) set Duality meters to show mic preamp level
   - in CHANNEL METERS, press INPUT
8. ) deselect all channels by pressing + and - together

Question 5

How do you patch in microphones for Pre Fader Split?

Answer 5

1. ) plug in microphones to desired channels in the studio
2. ) patch mic tie lines into channel inputs corresponding to the tracks you wish to record on
   - MIC LINES (#) -> CHANNEL INPUTS (#) in the patchbay
3. ) turn on phantom power if you are using a condenser microphone
   - select channel you need by pressing SELECT at the very bottom of the channel
   - select +48V in the INPUT section of the central routing panel
4. ) record arm the DAW tracks
5. ) adjust mic preamp inputs with red knob at top of module
6. ) bring up faders to hear sound source