D&T Flashcards
(9 cards)
1
Q
Name the parts of a marking gauge and where they are located
A
spur on top, adjustable spur on top, stock square in middle, adjustment screw on stock, stem below
2
Q
What is the saw we do we use in DT
A
tenon saw
3
Q
Name the 3 chisel’s
A
bevel edged, firmer, mortise
4
Q
Name the parts of a sawing board
A
stop and hook
5
Q
What is the difference between jack plane and smoothing plane
A
jack is big smoothing is small
6
Q
Name the parts of a jack plane
A
cutting iron on higher metal, cap iron on lower metal, adjusting nut under metal, handle at end, adjusting lever at top of metal
7
Q
what is the correct name of Grannys tooth
A
Hand router
8
Q
Name parts of hand router
A
adjustment nut on top of blade, blade, handle, locking nut middle of blade, sole\metal
9
Q
What clamp is used in DT
A
G clamp
