Equipment installation

Question 1

When pouring a concrete footing, you should hold the steel rods in position with

Answer 1

Tie wires

Question 2

Adding reinforcing steel to concrete increases the_____ strength.

Answer 2

Tensile

Question 3

An inner plastic iner in a concrete form is used to

Answer 3

Create a smooth finish

Question 4

keady-mixca concrete must be used within_____hr after mixing.

Answer 4

1

Question 5

Which of the following should not be used as a covering to keep poured concrete from freezing?

Answer 5

Salt

Question 6

Retainers on the sides of horizontally reciprocating equipment keep it from

Answer 6

Walking

Question 7

What type of wrench should you use for tightening anchor bolts?

Answer 7

Torque

Question 8

Which of the following should be used to set equipment anchor boits in an existing foundation?

Answer 8

Grout

Question 9

Grout must be used within_____ of mixing

Answer 9

15mins

Question 10

What must you do first before disconnecting the electrical wiring to existing equipment?

Answer 10

Shut of the power

Question 11

Where can you locate the recommended tiling points on a piece of equipment?

Answer 11

Equipment blueprint

Question 12

Using a block and tackle, what is the maximum load that can be lifted with a pull of 100 ib and six parts of the fall in the movable block?

Answer 12

600lb

Question 13

Which of the following makes the strongest sling?

Answer 13

Chain

Question 14

To keep your body tieat from affecting a master precision level, you should handle it by its

Answer 14

non-heat conductive top plate

Question 15

the common dial indicator is usualy used with ____base

Answer 15

Magnetic

Question 16

When an alignment screw is finally set, you can prevent further movement by

Answer 16

applying a sealing compound

Question 17

When an alignment screw is finally set, you can prevent further movement by

Answer 17

Bench level

Question 18

Which of the following levels requires a movable target?

Answer 18

Optical

Question 19

When using a wire mike for checking vertical alignment, the weight should be

Answer 19

suspended in a pail of light on

Question 20

Which of the following is true for aligning mating parts on a piece of equipment?

Answer 20

Use one reference point for all parts

Question 21

A mechanic’s level is precise enough for aligning

Answer 21

convoyors

Question 22

You can keep the fluid pressure in a line near a preset level with a _____valve.

Answer 22

Regulating

Question 23

A copy of the manufacturers test data is often attached to the_____ of new equipment.

Answer 23

manual

Question 24

What is the first rule for connecting equipment to electric power?

Answer 24

Start connecting at the equipment

Question 25

Which term is used to describe starting and stopping a newly installed motor to ensure it rotates in the correct direction?

Answer 25

Bump