Equipment Installation - Fusion

Question 1

The best materials for filling around a foundation are gravel and

Answer 1

ground concrete slabs

Question 2

The type of bolt to anchor the equipment is usually specified by the

Answer 2

equipment manufacturer

Question 3

How long must new concrete sit before you can install equipment on it?

Answer 3

28 days

Question 4

Adding reinforcing steel to concrete increases the ____ strength

Answer 4

tensile

Question 5

Which type of reinforcing steel bar holds in the concrete best?

Answer 5

Deformed

Question 6

An inner plastic liner in a concrete form is used to

Answer 6

create a smooth finish

Question 7

Retainers on the sides of horizontally reciprocating equipment keep it from

Answer 7

Walking

Question 7

Which of the following should be used to set equipment anchor bolts in an existing foundation?

Answer 7

grout

Question 8

To drill anchor bolt holes larger than 1 /2 in. you should use a

Answer 8

core bit with a diamond or carbon tip

Question 9

Anchor bolts should have _____ series threading

Answer 9

NC

Question 10

To smooth an exposed area of grout, you should

Answer 10

cover it with mortar

Question 10

If new equipment is damaged in shipment, you should report it to the

Answer 10

carrier

Question 11

What is the least number of rollers you should use under a load on a skid?

Answer 11

Three

Question 12

When moving equipment with a crowbar, what should you use between the bar and the floor?

Answer 12

A wood block

Question 13

If you have no clearance to remove a sling after setting the equipment down, you should lower the equipment onto

Answer 13

wedges

Question 14

Which of the following makes the strongest sling?

Answer 14

chain

Question 15

To support a level across machine tool ways in different planes, you should use precision ground parallels, or

Answer 15

gauge blocks

Question 16

Which of the following levels requires a movable target?

Answer 16

optical

Question 17

When using a wire mike for checking vertical alignment, the weight should be

Answer 17

suspended in a pail of light oil

Question 18

A copy of the manufacturer’s testate is often attached to the ____ or new equipment

Answer 18

manual

Question 18

The external air lines on equipment usually terminate just beyond filter or a

Answer 18

regulator

Question 19

You can keep the fluid pressure in a line near a preset level with a ____ valve

Answer 19

regulating

Question 20

High temperatures during equipment start-up is usually caused by

Answer 20

poor lubrication

Question 21

What is the first rule for connecting equipment to electric power?

Answer 21

start connecting at the equipment

Question 22

Which term is used to describe starting and stopping a newly installed motor to ensure it rotates in the correct direction?

Answer 22

Bump