Flashcards in Flight Controls Deck (22):
When are the electric trim switches inhibited
When more than one auto pilot engaged
Mach speed trim warning may also be associated with ?
Airspeed unreliable. May be the cause.
Rudder ratio operates at what speed
Speed brake deploys when on ground
Thrust lever to idle
Gear has gone out of tilt mode ie on ground
Speed brake light on when
Below800 feet with landing flap in landing config
Take off range for stab trim
2 to 7 units.
Stab trim light
Indicates half trim rate when electric trim used
How many spoilers work in flight
How many spoilers operate on the ground
Airspeed from which air data computer goes to rudder ratio
Speed brake and speed brake ext show when
Below 800 feet with landing flap extended and speed brake extended
Max flap speeds
Auto pilot trims the stabiliser at what speed.
Alto speed brake light means?
Fault in system.
Conditions for auto speed brake to work
Wheels out of tilt ie on ground
Thrust lever idle
If speed brake not armed then thrust levers to reverse
PTU supplies hydraulic fluid to what systems.
Load relief works for what flap
30* 162 knots
What happens at the stall with take off flap selected
Slats automatically extend to full extend.
When pushing either alternate LE or TE flap switch what does this do.
Depressurises both power drive units
But only arms the respective PDU
Using alternate flap extension what do the slats go to.
Full landing slat position.
LE Slat Disagree light
Hydraulic power to slats is cut off