Flight Instruments, Displays Flashcards

1
Q

Which ND mode displays the glide slope deviation diamond

A

Rose ILS Mode

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

A DMC failure is indicated by

A

A diagonal line on three DUs

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What control will you use if the Captain’s PFD, ND and upper ECAM screen have a diagonal line through them

A

Place EIS DMC selector to CAPT 3 position

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What does the blue 1 along the speed scale indicate

A

V1

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What does the amber = sign on the side of the speed scale indicate?

A

Next flap extended speed (VFE next)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Lowest selectable airspeed (Vls) is indicated by the

A

Top of the amber strip along the speed scale (this graphic 140 knots)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Alpha protection is indicated by

A

Top of the black and amber strip along the speed scale (132 knots in this example)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Alpha maximum speed is indicated by the

PFD shows red strip on airspeed tape at 125 KIAS

A

Top of the red strip along the top of the speed scale (125 knots in this example)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Where is selected altitude displayed on the altitude scale

A

Within a blue box on the altitude scale

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

The vertical deviation indicator is depicted on the PFD by

A

The magenta o on the altitude scale

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What is the actual indicated airspeed shown below.

PFD shows airspeed 205 with increasing trend

A

205

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What is the selected airspeed show below.

PFD shows a blue arrow pointing to 230 KIAS

A

230

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

According to the graphic, minimum slat retraction speed is ___ knots.
(PFD has green “S” and tick mark at 188 KIAS)

A

188

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

According to the graphic, minimum flap retraction speed is

PFD shows “F” with tick mark at 145 KIAS

A

145

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

According to the graphic, what is the UA limit next flap extended speed?
(PFD shows amber “=” on airspeed tape at 230 KIAS)

A

220

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

According to the graphic, the selected altitude off scale is ___ feet.
(PFD shows 3000 feet in blue below the altitude tape)

17
Q

The beta target is displayed when

A

CONF 1, 2, or 3 and either engine EPR exceeds 1.25 and the difference between EPRs exceeds .25.

18
Q

The ground roll guidance command bar provides Flight Director yaw commands when

A

A localizer signal is available during takeoff.

19
Q

What is the purpose of the sidesticks order indication?

A

Allows pilots to observe commanded sidestick deflection during takeoff and landing roll.

20
Q

What is indicated by the green “510” indication on the bottom of the attitude indicator?

A

Radio height.

21
Q

How is flight director (FD) guidance displayed on the PFD in the TRK-FPA mode?

A

By a single guidance bar to indicate desired FPA and bank.

22
Q

When the flight path vector (FPV) is on the horizon line, the flight path angle of the airplane is ___ degrees.

23
Q

Flying the flight path vector (FPV) 3 degrees below the attitude indicator horizon line will always produce

A

A 3 degree flight path below the horizon.

24
Q

What is indicated by the green arrow under the green 050/65?

A

Magnetic wind direction.

25
According to the graphic, what is the groundspeed of the airplane in knots? (ND upper left corner says GS 392)
392
26
According to the graphic, the #3 DMC is providing information to the Captain's (Picture shows switching panel EIS DMC set to CAPT 3)
PFD, ND, and the E/WD.