Ham Tech Class - Set 8 Flashcards
(48 cards)
Which of the following is a form of amplitude modulation?
C. Single sideband - T8A01 (C)
What type of modulation is most commonly used for VHF packet radio transmissions?
A. FM - T8A02 (A)
Which type of voice mode is most often used for long-distance (weak signal) contacts on the VHF and UHF bands?
C. SSB - T8A03 (C)
Which type of modulation is most commonly used for VHF and UHF voice repeaters?
D. FM - T8A04 (D)
Which of the following types of emission has the narrowest bandwidth?
C. CW - T8A05 (C)
Which sideband is normally used for 10 meter HF, VHF, and UHF single-sideband communications?
A. Upper sideband - T8A06 (A)
What is an advantage of single sideband (SSB) over FM for voice transmissions?
C. SSB signals have narrower bandwidth - T8A07 (C)
What is the approximate bandwidth of a single sideband (SSB) voice signal?
B. 3 kHz - T8A08 (B)
What is the approximate bandwidth of a VHF repeater FM phone signal?
C. Between 10 and 15 kHz - T8A09 (C)
What is the typical bandwidth of analog fast-scan TV transmissions on the 70 centimeter band?
B. About 6 MHz - T8A10 (B)
What is the approximate maximum bandwidth required to transmit a CW signal?
B. 150 Hz - T8A11 (B)
What telemetry information is typically transmitted by satellite beacons?
C. Health and status of the satellite - T8B01 (C)
What is the impact of using too much effective radiated power on a satellite uplink?
B. Blocking access by other users - T8B02 (B)
Which of the following are provided by satellite tracking programs?
D. All of these choices are correct (A. Maps showing the real-time position of the satellite track over the earth, B. The time, azimuth, and elevation of the start, maximum altitude, and end of a pass, C. The apparent frequency of the satellite transmission, including effects of Doppler shift) - T8B03 (D)
What mode of transmission is commonly used by amateur radio satellites?
D. All of these choices are correct (A. SSB, - T8B04 (D)
What is a satellite beacon?
D. A transmission from a satellite that contains status information - T8B05 (D)
Which of the following are inputs to a satellite tracking program?
B. The Keplerian elements - T8B06 (B)
With regard to satellite communications, what is Doppler shift?
C. An observed change in signal frequency caused by relative motion between the satellite and the earth station - T8B07 (C)
What is meant by the statement that a satellite is operating in mode U/V?
B. The satellite uplink is in the 70 centimeter band and the downlink is in the 2 meter band - T8B08 (B)
What causes spin fading of satellite signals?
B. Rotation of the satellite and its antennas - T8B09 (B)
What do the initials LEO tell you about an amateur satellite?
C. The satellite is in a Low Earth Orbit - T8B10 (C)
Who may receive telemetry from a space station?
A. Anyone who can receive the telemetry signal - T8B11 (A)
Which of the following is a good way to judge whether your uplink power is neither too low nor too high?
D. All of these choices are correct (A. Check your signal strength report in the telemetry data, B. Listen for distortion on your downlink signal, C. Your signal strength on the downlink should be about the same as the beacon) - T8B12 (C)
Which of the following methods is used to locate sources of noise interference or jamming?
C. Radio direction finding - T8C01 (C)