Maintenance Publications

Question 1

Airworthiness Directives are issued primarily to…

Answer 1

Correct an unsafe condition.

Question 2

Answer 2

Only 1 is true.

Question 3

What does the acronym TSO mean regarding a type certificated aircraft part, material, component and/or process?

Answer 3

Technical Standard Order.

Question 4

Primary responsibility for compliance with Airworthiness Directives lies with the…

Answer 4

Aircraft owner or operator.

Question 5

An aircraft Type Certificate Data Sheet contains…

Answer 5

Location of the datum.

Question 6

Suitability for use of a specific propeller with a particular engine-airplane combination can be determined by reference to what informational source?

Answer 6

Aircraft Specifications or Aircraft Type Certificate Data Sheet.

Question 7

When an aircraft is sold domestically, the Airworthiness Certificate…

Answer 7

Is transferred with the aircraft at the time of sale.

Question 8

The issuance of an Airworthiness Certificate is governed by…

Answer 8

14 CFR Part 21.

Question 9

Specifications pertaining to an aircraft model manufactured under a type certificate of which less than 50 are shown on the FAA Aircraft Registry, can be found in the…

Answer 9

Aircraft Listing.

Question 10

Where are technical descriptions of certificated propellers found?

Answer 10

Propeller Type Certificate Data Sheets.

Question 11

What information is generally contained in Aircraft Specifications or Type Certificate Data Sheets?

Answer 11

Control surface movements.

Question 12

Placards required on an aircraft are specified in…

Answer 12

Aircraft Specifications or Type Certificate Data Sheets.

Question 13

Technical information about older aircraft models, of which no more than 50 remain in service, can be found in the…

Answer 13

Aircraft Listing.

Question 14

Which of the following are sometimes used as authorization to deviate from an aircrafts original type design?

Answer 14

FAA Form 337, Supplemental Type Certificate, and Airworthiness Directive.

Question 15

Answer 15

Only 1 is true.

Question 16

Which regulation provides information regarding instrument range markings for an airplane certificated in the normal category?

Answer 16

14 CFR Part 23.

Question 17

Which regulation provides the airworthiness standards for an airplane certificated in the normal category?

Answer 17

14 CFR Part 23.

Question 18

What regulations are covered by 14 CFR Part 1?

Answer 18

Definitions and abbreviations.

Question 19

Answer 19

Only 2 is true.

Question 20

An aircraft mechanic is privileged to perform major alterations on U.S. certificated aircraft; however, the work must be done in accordance with FAA-approved technical data before the aircraft can be returned to service. Which is NOT approved data?

Answer 20

AC 43.13-2A

Question 21

What is the maintenance recording responsibility of the person who complies with an Airworthiness Directive?

Answer 21

Make an entry in the maintenance record of that equipment.

Question 22

Answer 22

Only 2 is true.

Question 23

A Technical Standard Order (TSO) is issued by whom?

Answer 23

The Administrator.

Question 24

Answer 24

Both 1 and 2 are true.

Question 25

Aviation Maintenance Alerts (formerly General Aviation Airworthiness Alerts)...

Answer 25

Provide information about aircraft problems and suggested corrective actions.

Question 26

(Refer to Figure 62.) The -100 in the title block (Area 1) is applicable to which doubler part number(s)?

Answer 26

-101

Question 27

(Refer to Figure 63.) An aircraft has a total time in service 468 hours. The Airworthiness Directive given was initially complied with at 454 hours in service. How many additional hours in service may be accumulated before the Airworthiness Directive must again be complied with?

Answer 27

186.

Question 28

The following words are an example of what kind of statement in an AD? "Required within the next 25 hours time-in-service after the effective date of this AD, unless already accomplished."

Answer 28

Compliance.

Question 29

The action required by an AD may take what form?

Answer 29

1,2,3, and/or 4.

Question 30

Type Certificate Data Sheets are issued for which of the following products?

Answer 30

Aircraft, engines, and propellers.

Question 31

Answer 31

139 knots.

Question 32

When is a mechanic responsible for checking AD compliance?

Answer 32

When performing an inspection required under part 91, 125, or 135.

Question 33

How long are AD compliance records required to be kept?

Answer 33

They shall be retained, and then transferred with the aircraft when it is sold.

Question 34

What does the Type Certificate Data Sheet designation code "2 PCSM' mean? (K01)

Answer 34

Two place (number of seats), closed, sea, monoplane.

Question 35

Which of the following includes all the regulatory definitions of "maintenance"?

Answer 35

Overhaul, repair, parts replacement, inspection, and preservation.

Question 36

What is the maximum penalty for cheating or other unauthorized conduct when taking an FAA mechanic test?

Answer 36

Ineligibility to receive any certificate or rating for one year, and suspension or revocation of any certificate held.

Question 37

Answer 37

100 hours.

Question 38

Answer 38

150 hours.