Q6 Flashcards
(81 cards)
- What is considered an impact load fall when using an Atlas Belt or Personal Harness?
3 feet
- How far away is the flare placed from the blocking apparatus when the expected speed is 50 MPH?
310 = (50 x 5) + 60
- T or F: If the Low-Pressure Gauge reads less than 200 psi during operation, you should change the cylinder.
False
- Which statement is true in regards to Maxi-Airbags?
The rated tonnage is how much weight the bag can lift 1 inch high.
- What is true about Maxi-Airbags?
Safety Relief Valve releases air in excess of 118 psi.
- What is INCORRECT in regards to the 2nd due inside team at a 12th floor Non-Fireproof Multi-Dwelling fire?
They assist the officer in designating the attack stairwell. (Incorrect: They recall elevators & search attack stairs 5 floors above and communicate with engine & ladder officer on fire floor to confirm the attack and evacuation stairways. They do not assist the officers.)
- Which of these ladder company tool assignments to a High-Rise Multi-Dwelling is INCORRECT?
2nd Due Roof brings KO Curtain, Halligan and Hydra-Ram.
- What is correct about Fireproof Multiple Dwellings?
Use the stairs for fires on the 7th floor or below. 8th floor and above can use the elevator. Take to 2 floors below fire floor.
- What is INCORRECT regarding car fires?
Park the apparatus between the fire and the exposure. (Incorrect: Hoseline should be placed there.)
- What is the correct placement of an apparatus at an auto fire?
Operating engine can be placed between the fire and an exposure depending on the situation and the blocking apparatus must always be placed in the way of oncoming traffic.
- Which of the following is INCORRECT in regards to venting a window with portable ladders?
When venting with a portable ladder, keep your hands on the rails to stabilize the ladder while you vent.
- The ability of foam to resist saturation by hydrocarbons is __________.
Fuel Shedding
- When is the personal harness inspected?
Beginning of each tour & after each use.
- T or F: When lowering a member with a personal harness, the member being lowered unties the bowline on a bight and clips the snap hook onto the repel hook.
False (You clip into the handle of the harness.)
- What is INCORRECT when venting a flat roof on a Non-Fireproof Multiple Dwelling?
Rev Diamond Brazed Blade to full RPM’s (Incorrect: Carbide Tip Blade is meant for roof cutting of non-FP MD, not Diamond Blade.)
- What is correct in regards to partner saw operations?
Moving the Saw back & forth can widen the cut & helps prevent the blade from binding.
- What about partner saw operations is correct?
One slap means to stop cutting. (2 slaps – Start Saw, 3 slaps – Shut Down Saw.)
- T or F: When the primary PRA fails, air comes out at 185 psi and the Vibralert goes off.
False (185 psi is for secondary failure, 150 psi is for primary failure.)
- Which of the following is INCORRECT in regards to purge valve use?
If the regulator is stuck in the open position, turn purge valve counterclockwise.
- T or F: When performing a leg lock, the member uses the working side and goes 2 rungs above the rung they are standing on.
False (Should be opposite of the working side.)
What does a CO reading of 25 ppm indicate?
An Emergency
What is an incorrect statement about saw operations?
During cutting operations, everyone in the vicinity of a saw shall observe as near as possible and practical, a 20’ diameter known as the circle of danger. (20’ Radius)
Who is in charge of turning off the utilities in a first floor fire of a 2nd story taxpayer?
First due inside team
What is not necessary for first due irons FF to bring to a first floor fire of a two story taxpayer?
Hydraram