QW-123 TEST POSITIONS FOR STUD WELDS

Question 1

QW-123.1 Stud Welding. Stud welds may be made in test coupons ___1___ in any of the positions as described in QW-121 for plate and QW-122 for pipe (excluding QW-122.1). In all cases, the stud shall be ___2___ to the surface of the __3___ or pipe

Answer 1

1)Oriented

2)Perpendicular

3)Plate

Question 2

QW-124 SPECIAL POSITIONS

QW-124.1 Test positions other than those defined in ___1__ through ___2___ are defined as __3___

Answer 2

1)QW-120

2)QW-123

3)Special positions

Question 3

QW-130 TEST POSITIONS FOR FILLET WELDS

Fillet welds may be made in test coupons oriented in any of the positions of Figure QW-461.5 or Figure QW-461.6, and as described in the following _____1___, except that an angular ___2___ of ±15 deg from the specified horizontal and vertical planes is ___3___ during welding.

Answer 3

1)paragraphs

2)Deviation

3)Permitted

Question 4

QW-131 PLATE POSITIONS

QW-131.1 Flat Position 1F. Plates so placed that the weld is ___1___ with its axis horizontal and its ___2___ ___3___. Refer to Figure QW-461.5, illustration (a)

Answer 4

1)Deposited

2)Throat

3)vertical

Question 5

QW-131.2 Horizontal Position 2F. Plates so placed

that the weld is deposited with its _____1_____ on the ___1___ side of the horizontal surface and ___2___ the vertical surface. Refer to Figure QW-461.5, illustration (b).

Answer 5

1) axis horizontal

2)Upper

2)Against

Question 6

QW-131.3 Vertical Position 3F. Plates so placed that the weld is deposited with its __1__ vertical. Refer to Figure QW-461.5, illustration (c).

Answer 6

1)Axis

Question 7

QW-131.4 Overhead Position 4F. Plates so placed that the weld is deposited with its _____1_____ on the ___2___ of the _____3____ surface and against the vertical surface.

Answer 7

1)axis horizontal

2)Underside

3)horizontal

Question 8

QW-132.1 Flat Position 1F. Pipe with its axis inclined at 45 deg to horizontal and rotated during welding so that the weld __1___ is deposited from ____2____ and at the point of deposition the __3__ of the weld is horizontal and the throat vertical. Refer to Figure QW-461.6, illustration (a).

Answer 8

1)Metal

2)Above

3) axis

Question 9

QW-133 SPECIAL POSITIONS

QW-133.1 Test positions other than those defined in ___1___ through __2___ are defined as “______3______.”

Answer 9

1)QW-130

2)QW-132

3)special positions

Question 10

QW-141.1 Tension Tests. ______1____ as described in ___2___ are used to determine the _______ 3_______ of groove‐weld joints.

Answer 10

1) Tension tests

2)QW-150

3) ultimatestrength

Question 11

QW-141.3 Fillet-Weld Tests. Tests as described in QW-180 are used to determine the __1___, ____2____, and ___3___ of soundness of fillet welds.

Answer 11

1)Size

2)Contour

3)Degree