SCBA Week Flashcards

1
Q

How many firefighters are needed to rescue a down firefighter in a basement?

A

3 (ideally 4)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

When transfilling between SCBA’s which SCBA is the donor and which is the receiver?

A

The one with a higher pressure is the doner and the one with the lowest pressure is the receiver

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

When would you NOT transfill to another SCBA?

A

If you’re low pressure warning device is sounding. Doner’s bottle must be at least 2,000 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

When does the SCBA low pressure warning begin sounding?

A

at 35% (plus or minus 2%), or at 1,500-1,575 psi or 1/3 of bottle pressure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What apparatus’s are the S-Cut tool located on?

A

Distract Chief Vans, Both FRP units, all Rescues

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Which shoulder strap of the SCBA is the first to put on and the last to take off?

A

The left side - because your air hose is on the left side

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What are the 4 distinct SCBA emergencies?

A
  • Straps, buckles, and harness
  • face piece
  • hoses and regulator
  • out of air and cylinder
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

If you have a problems with your SCBA straps how long should you spend remedying the problem before exiting the IDLH environment due to strap problem?

A

30 seconds

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

If you experience a backplate or harness failure what should you do?

A

Exit structure immediately

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

if your face piece cracks or melts (also known as crazing) what should you do?

A
  • Get as low to ground as possible and try to cover sense as best you can. If lens is melting don’t put any pressure on lens
  • call mayday
  • exit structure
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

If your SCBA hose is cut what type of breathing should you consider? and what should you do?

A

Wheel breathing

place hose in jacket and continue breathing if possible

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What is wheel breathing?

A

This is where you control the air flow by opening and closing the cylinder wheel by hand. You open the cylinder just to take a breath and then close it.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What should you do if you run out of air?

A

1) shield your airway
2) stay low
3) call MAYDAY
4) Consider transfilling of possible
5) exit structure if possible

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What color is the Air light fill station tag?

A

Green

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What color is the training academy fill station tag?

A

Blue

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What color is the High Rise Support fill station tag?

A

Yellow

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

What color is the station 16 fill station tag?

A

Pink

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
18
Q

What color is the Vehicle and Equipment Maintenance fill station tag?

A

Orange

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
19
Q

How many cylinders can Station 16 fill at once?

A

10 SCBA, 3 SCUBA, 1 Escape pack

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
20
Q

At what PSI will a CFD cylinder burst disc rupture?

A

6750 psi

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
21
Q

Air in SCBA gets stale, at what date should you refill air in cylinders?

A

Within 6 months

22
Q

How long should it take to refill a cylinder to avoid hot filling it?

A

approximately 15 mins

23
Q

When should you not use the academy fill station?

A

if wind greater than 15 knots is coming out of the east to south east and the burn tower or burn pans are being used.

24
Q

When your cylinders air reaches 1/2 what should you do?

A

Notify your officer

25
What are the 10 components of SCBA?
1) face piece 2) regulator 3) HUD (heads up display) 4) cylinder and control valve assembly 5) pressure reducer with low pressure warning device 6) control module with integrated thermal imaging camera 7) power module 8) harness and carrier assembly 9) speaker module 10) quick-fill pouch
26
What do the lights on the HUD mean?
Right Side: 4 lights indicating air level Left side: status icon, evacuation icon, low battery icon
27
What are the 3 components of the G1 SCBA PASS device?
battery module, power module, and control module
28
Can the D-rings on the backplate of the SCBA be another method to remove a down firefighter? and what weight is each backplate D-ring rated too?
Yes - 500lbs
29
How long is the Nomex Quick Transfix hose? and which side of the SCBA is it on?
A 3 feet hose on the right side
30
What is the acceptable range that the control module pressure gauge must be with the cylinder pressure gauge?
within 5% (225 psi)
31
What are the 4 segments of the HUD pressure lights?
4 green lights = 75-100% 3 green lights = 50-75% 2 flashing Yellow lights = 49-36% 1 flashing red light = 0-35%
32
What could this mean?
Pass Pre-Alarm, Electronics Failure, or Primary Thermal Alarm
33
What could this mean?
Pass Full Alarm, or Pass Manual Alarm
34
What could this mean?
Secondary Thermal Alarm, or LCD Thermal Alarm
35
What does this indicate on the control module?
Thermal alarm primary
36
What does this indicate on the control module?
LCD Temp Alarm
37
What does this indicate on the conrol module?
Motion Pre-alarm
38
What does this indicate on the control module?
Motion/manual full alarm
39
What does this indicate on the control module?
evacuation alarm
40
what does this indicate on the control module?
for any active or new warning
41
What is the thermal alarm meant to indicate for firefighters?
As a reference only that the temperature is increasing in rapid time
42
What percentage of battery remains?
60-79%
43
What percentage of battery remains?
40-59%
44
What percentage of battery remains?
20-39%
45
What percentage of battery remains?
0-19%
46
What does a single press of the green button do on the PASS device?
Activates backlight, refresh the HUD, and toggle between primary and secondary screens.
47
What does a double press of the green button do?
Reset PASS alarm, confirm evacuation, turn off the device (when pressure is below 200 psi), or clear primary alarms
48
When cleaning SCBA facepiece how much Ecolab Neutral Disinfectant Cleaner should you add to the cleaning pail?
1/2 cup or 125ml
49
When cleaning the SCBA facepiece how long should you leave the facepiece and nose cup sitting in the solution?
at least 10 minutes
50
How should the high-pressure RIC transfer hose be stored in the pouch?
With an S-shaped bend
51
At what pressure do you replace/fill SCBA cylinder?
When less than 4000 psi