Systems 2

Question 1

Where is the T-1’s main battery located?

Answer 1

Aft compartment

Question 2

Describe the T-1’s main battery.

Answer 2

24 volt, lead acid 40 amp

Question 3

What is the minimum voltage for battery start?

Answer 3

22

Question 4

Can the main battery supply power to all DC buses and both inverters?

Answer 4

Yes

Question 5

Where is the external power receptacle located?

Answer 5

Under left (no 1) engine

Question 6

What kind of power does the external power receptacle provide?

Answer 6

28 volts

Question 7

What is an electrical bus?

Answer 7

Power strip/distributor

Question 8

What is a remote control circuit breaker (RCCB)?

Answer 8

A circuit breaker that controls a relay. A SPECIAL KIND OF CIRCUIT BREAKER NOT ACCESSIBLE FROM COCKPIT

Question 9

What type of circuit breakers protect the LH and RH Radio buses?

Answer 9

Switch type circuit breakers

Question 10

What type of circuit breakers protect non-essential buses?

Answer 10

Switch

Question 11

Each generator supplies how many volts of what type of power?

Answer 11

28 volts of DC

Question 12

Describe the generator’s power output.

Answer 12

28 volts DC power. 280 amps (ground). 400 amps (single).

Question 13

What is the maximum load on the ground with only one engine operating?

Answer 13

280 amp

Question 14

What component allows the generators to operate in parallel and share the DC load?

Answer 14

Generator Control Unit (GCU)

Question 15

What are the positions of the Master Generator Switches?

Answer 15

EMER and NORM

Question 16

How many bus feeders are powered?

Answer 16

2 out of 3

Question 17

How many volts does a fully charged STBY battery have and where is it located?

Answer 17

24 volts and in the nose

Question 18

Where is the STBY PWR switch located?

Answer 18

Copilot Instrument Panel. Center Instrument Panel

Question 19

How would you arm the STBY system?

Answer 19

Push the button

Question 20

What buses can the STBY run?

Answer 20

The standby buses

Question 21

What does placing the battery switch in EMER activate?

Answer 21

Emergency Bus, STBY battery, STBY Bus, AUX battery, AUX STBY Bus

Question 22

Is any trim system available when operating on emergency and standby power after a dual generator failure?

Answer 22

Emergency trim switch (center console)

Question 23

What are the AC Power sources?

Answer 23

½ inverter

Question 24

What kind of power voltage do the inverters provide?

Answer 24

26 volt / 115 volt

Question 25

What is the normal power source for the No 1 inverter?

Answer 25

LH Load Bus

Question 26

From where does the No 2 inverter normally receive power?

Answer 26

RH Load Bus

Question 27

What should the AC voltmeter selector normally be left in?

Answer 27

No 1 / 115 volt position

Question 28

What are the Inverter Selector Switch Positions?

Answer 28

Auto / No 1 / No 2

Question 29

With the inverter selector switch in the No 2 position, what buses are powered?

Answer 29

Primary Buses / Secondary are depowered

Question 30

Under what condition will the AC bus shed relay open and depower the AC shed bus?

Answer 30

No 2 Inverter powered by Emergency Bus

Question 31

What are the landing light limitations?

Answer 31

200 KIAS / FL200

Question 32

What lights are controlled by the overhead panel switch labeled NAV?

Answer 32

Navigation lights (red green white)

Question 33

What lights are controlled by the overhead ANTI – COL switch?

Answer 33

Anti collision lights (white flashers)

Question 34

What is the rotating beacon?

Answer 34

Red beacon on tail

Question 35

What lights are the wing inspection lights?

Answer 35

White wing inspection lights (steady white on wings)

Question 36

What happens when the landing lights are extended and illuminated and the gear comes up?

Answer 36

Retract and extinguish automatically

Question 37

Can the landing lights be extended when the landing gear is up?

Answer 37

Yes

Question 38

How would you know when landing lights are extended?

Answer 38

Annunciator

Question 39

How are passenger reading lights controlled?

Answer 39

Button over passenger

Question 40

How are the instrument panel floodlights controlled?

Answer 40

Flood light switch

Question 41

In order to use pilot and copilot instrument lights, the integral switch must be _______.

Answer 41

ON

Question 42

Under what condition will instrument panel flood lights illuminate automatically?

Answer 42

LH Load bus loses power AND INTEG switch in ON

Question 43

What controls the T-1 emergency lighting system?

Answer 43

Overhead control panel EMER switch

Question 44

What cabin lights should illuminate when the EMER switch is on?

Answer 44

Flood lights and exit lights

Question 45

What powers the cabin lights when the EMER switch is on?

Answer 45

Each light has its own battery

Question 46

What is the indicator for single generator failure?

Answer 46

Master caution, AMP gauges, GEN FAIL annunciator

Question 47

What happens when L and R GEN are off?

Answer 47

Ammeters are zero

Question 48

What is the first action if INV 1 FAIL occurs?

Answer 48

Check circuit breaker

Question 49

If No 1 Inverter fails, what will No 2 Inverter power?

Answer 49

Primary AC bus

Question 50

What position should the voltage select knob be in during a single inverter failure?

Answer 50

115 V of working inverter

Question 51

When does the AC Bus Shed annunciator illuminate?

Answer 51

When No2 inverter is powering primary buses AND when EMER BUS is powering No2 inverter

Question 52

What happens if the Battery FDR FAIL is illuminated with no other indications?

Answer 52

Batt cut off / Emer Bus FDR Fail

Question 53

What would be your primary indication that the emergency bus feeder failed?

Answer 53

EMER BUS FDR FAIL

Question 54

What is the secondary indication of an emergency bus feeder failure?

Answer 54

Circuit breaker popped

Question 55

What does illumination of (L or R) BUS FDR FAIL indicate?

Answer 55

The 3rd feeder has been powered

Question 56

How many times can you reset a BUS FDR circuit breaker?

Answer 56

Zero or none

Question 57

What does illumination of the batt cut off annunciator indicate?

Answer 57

Battery is isolated

Question 58

When does the smoke detector illuminate?

Answer 58

When it detects smoke – located by avionics rack

Question 59

What does an acrid smell and smoke from the avionics rack indicate?

Answer 59

Electrical fire

Question 60

What is the first action during an electrical fire?

Answer 60

Don masks

Question 61

Why is the electrical fire checklist to ensure XFEED is normal?

Answer 61

Prevent loss of thrust and engine flameout

Question 62

Which buses are powered when STBY PWR armed, and Master Generator Switches are EMER?

Answer 62

Standby buses

Question 63

What comm/nav systems are available when only STBY power is on?

Answer 63

UHF (STBY Bus)

Question 64

What hydraulic power systems are affected when EMER or STBY power only?

Answer 64

Landing gear – normal extension, Flaps stuck, Speed brakes (blown down), Anti skid – off