JET 01 Treating Equipment Flashcards
Can you put a suction hose on the discharge side of a centrifugal pump?
no
Hard hoses (4-in) may be used in the discharge side under the following circumstances.
Not allowed under any circumstances
What is Well Services iron tested to?
1.5 times the working pressure
What is the maximum pressure of a 4 in
discharge hose?
100 to 125 psi
What is the maximum pressure of a FMC
butterfly valve?
175 psi.
High-pressure treating equipment is
hooked up from a positive displacement
pump to pump into a wellhead or other
high-pressure systems?
TRUE
When not in use, hoses should be stored
in __________.
a. cool places
b. dark places
c. away from electrical equipment
d. away from direct sunlight
__________ is the nominal ID of 2-in
15,000 WP treating pipe.
1.875 in
In an 2-in FMC Chiksan, the number of
steel balls per race is __________.
24
An important use of the 1x2 plug valve is
__________.
bleed off valve on the treating line
How many seal segments are there on a
2-in plug valve.?
2
Safety Standard 23 requires that all 2-in
1502 wing nuts stamped __________ to
be removed from service.
test
Based on erosion studies on the Chiksan,
the wing on treating iron should face the
__________.
well
When changing elevation, use a
__________ Chiksan configuration.
3-way
When changing direction, use a
__________ Chiksan configuration.
2-way
