chapter 18 Inspection and Training Flashcards
Inspection is necessary to ensure that the ______ of the specification, as well as its ____ are carried out.
Intent
details
In all cases, the coating is a _____ film separating two _____ materials.
Thin
reactive
Coating inspectors may be provided by ____ _____ , independent _____ firms, or by ______ engineers and ____ painters.
Coating manufacture
consulting
corrosion
retired
For an inspector to properly ______ the specification, he or she must have a thorough understanding of the _____ of the specification.
interpret
intent
Concrete surfaces, because of both their ______ and their _____ surfaces, present different problems than when coating a ______, _____, _____ steel surface.
reactivity
variable surfaces
dense, smooth, clean
A good inspector should have sound knowledge of surface preparation, not only for flat steel, but also for other surfaces such as ________, ________, and _______.
galvanizing
concrete
aluminum
A coating inspector should understand that the coatings tend to ____ _____ from corners and edges, as well as ____ splatter
pull away
weld splatter
the inspector should know the different _____ characteristics of each different coating specified for each job.
Application
The inspector should know the characteristics of both ____ and _____ spray, and be familiar with the ______ to properly apply coatings with each type of equipment.
air and airless
procedures
the inspector should, in all cases, avoid developing an _________ relationship with the ________.
adversary
contractor
As the representative of the owner, the inspector must have sufficient _____ of the specification and the _____ materials to act as _______ of the specification in order to ensure that the owner gets the job for which they contracted.
knowledge
coating
interpreter
The inspector should check the ______ on the container to determine whether or not the material bears the _______ and ______ as detailed in the specification.
Labels
designation and numbers
once the containers are opened, the inspector should check for material problems, such as ______, ______, ________, ______ ______, and hard pigment settling on the bottom, as well as the _____ to be used if thinning is necessary.
viscosity livering gelling pigment separation solvent
VIS-1
for abrasive blasted steel
VIS-3
for power tool cleaned steel
