Signal Irregularities Flashcards

1
Q

What information is given to area control/signaller/train control?

A

Train number
Signal post number
Position of train

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What are some signal irregularities?

A

Absence of an aspect at a place where a signal is normally shown
Signal imperfectly displayed (flickering, disc not turning correctly)
White light in place of colour
2 signal aspects instead of one (dwarf)
Conflicting co acting
Signal reverting to stop before train passes the signal

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

How should irregular signals be treated?

A

Safest aspect at STOP

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What can be issued when an irregular signal is detected

A

CAN notice

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Is a CAN notice an authority to pass a signal?

A

No

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the procedure of a home signal is stuck at proceed?

A

Hand signaller must obscure the light
Lay two ATWs ten meters apart at a sufficient distance away from the signal
Exhibit red hand signal until correct authority obtained by the driver to succeed

Driver must make a pa announcement
Obtain correct authority to pass

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What’s the procedure with a home reverting to stop?

A

Attempt to stop
Make a pa announcement
Communicate with signaller or tc
Obtain the necessary authority to pass

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What if there is no comms after seeing a home signal reverting to stop?

A

Wait to be contacted by tc

Must not pass unless correct authority is given

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What do you do with an automatic signal stuck at proceed?

A

Hand signaller must obscure the light
Lay two ATWs ten meters apart at a sufficient distance away from the signal
Exhibit red hand signal
Inform the driver to pass as per rule one section three

Driver must make a pa announcement
Pass as per rule one section 3

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What do you do when an automatic signal reverts back to stop with comms?

A

Stop if possible
Advise TC
Act under TCs instruction

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What do you do when an automatic signal reverts back to stop without comms?

A

If able to stop
Proceed as per R1S3

If unable to stop
Act as per instructions of trip in the vicinity
Continue to attempt communication
Do not proceed unless instructed by tc
Once authority is received act upon instructions

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Dwarf stuck on a proceed aspect, what is the procedure?

A

A hand signaller must
Obscure light
Signaller will act as the signal until it has been repaired
No ATWS are to be used in sidings
Driver must obtain verbal authority by signaller to pass

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

No operative light on a dwarf or disc, how do you proceed?

A

Verbal authority due to defective signal

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

If a signaller cannot be contacted due to issues with communication regarding an irregular aspect, who is the next point of cal?

A

Train Control

How well did you know this?
1
Not at all
2
3
4
5
Perfectly