Engine Flashcards

(34 cards)

1
Q

When the thermal discharge indicator is operated, what colour does the indicator display?

A

Red.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

When operating the Engine mode selection switches (EMSS), what is the make and brake time limit?

A

1 sec.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Where are the engine start busbars located?

A

CX + CY.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

what colour is the crossfeed discharge on the fire extinguisher bottles?

A

Grey.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is the normal operating temperatures of the electrically heated engine intake matts?

A

65 - 140 degree’s.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Which 2 additional functions does the exhaust system provide?

A

Engine bay ventilation and reduces the infrared (IR) signature of the engine.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

At what percentage NG will the igniters operate?

A

8%.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Where are the spark igniters located on the engine?

A

10 o’clock and 2 o’clock.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Where are the ice protection control units located?

A

No1 rear bay lower shelf No2 right bulkhead of rear bay.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

At approximately what NG will the engine contactor de-energise removing supply from the starter generator?

A

50% NG.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

In which condition will the ECU automatically abort the start on the ground?

A

NG is less than 50% within 30 seconds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What is the maximum temperature indicated by a red circle on the power turbine inlet temperature during start?

A

850 degrees.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What are the 5 primary components of the gas generator?

A
Front frame
Compressor
Combustion section
Gas generator Turbine
Rear Support.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Where does the torque meter measure the display torque?

A

The power turbine shaft.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

How would you describe the oil level indicator used in the engine oil tank?

A

A glass rod with a visual indicator.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

When the ENGOIL LVL caution illuminates, approximately how much useable oil remains in the tank?

17
Q

Where are the engine oil system metallic chip detector sensors located?

A

1 in the engine oil tank and 1 in the engine reduction gearbox.

18
Q

Which of the following engine anti icing system faults is considered to be a dormant failure.

A

Single functional failure.

19
Q

How are critical failures resulting in an over temperature of the heater matt indicated?

A

INTAKE#A/ICE warning, cautions and advisories, amber fail caption on the engine anti ice switch.

20
Q

Where is the power turbine speed sensor?

A

On rear support at approximately the 2 oclock position.

21
Q

What are the angle between the blades on the torque sensor?

22
Q

On the engine automatic relight (overspeed) what switch do you need to be made to ensure it relights automatically?

A

Starter master.

23
Q

What reduces the temperature of the exhaust?

A

Upper air scoop
Lower air scoop
IPS duct

24
Q

What are the removeable parts of the firewall?

A

Right quadrant panel
Left quadrant panel
Centre firewall top fairing
(1 centre 2 foreign)

25
How does the expandable pin for the engine lock?
It has a locating pip which engages with a hole in a spring lever to form a positive lock of the pin.
26
What is used to ensure correct installation of the mounting link assemblies?
They are marked INBOARD and OUTBOARD.
27
What does the ECU record?
NG, Np, Torque and PTIT
28
If you have an over temp on a heater matt what caution would you get?
Intake#fail
29
What is the default NR speed?
104% NR
30
Oil consumption should be no more than?
0.095L an hour
31
How many nozzles are there for fuel?
12
32
What are the voltages and sparks per second for the Ignition exciter?
``` 28v = 7 sparks 12v = 2 sparks ```
33
What is the maximum vent time?
15 secs
34
What happens to Anti Icing if power is lost?
Defaults to open position.