Fence height is ___________ - ___________ measured from the finished grade to the top of the pilaster cap.
5’8” - 6’2”
Replace damaged, defective, or blocks with chips larger than _______ inch in diameter.
1”
Gates are a minimum of _________ in height.
5’8”
Gates to be installed with ________ - _________ inches between the grade and the bottom of the gate.
3” - 5”
Provide a minimum of ________ inch gap between the slats and the wrought iron at each end.
1/8”
Gate slats not to be ______________, ___________, or have any _________ __________.
Warped
Cracked
Knot holes
Double gates to have a ____________ ____________ mechanism at the fixed panel.
Cane bolt
The gates cane bolt sleeve is to be a ________ inch square metal tube installed approximately ________ inches above the finish grade.
1”
2”
All gate latch assemblies are to operate _______________.
Smoothly
