FMS - TAKEOFF

Question 1

At acceleration altitude, push the autothrust pushbutton on the FCU and set the thrust levers to:

A) Heading hold

B) The Climb detent

C) The TOGA detent

D) The Max Continuous Thrust Detent

Answer 1

B) The Climb detent

Question 2

The Preflight Progress Page shifts to:

A) Flex Thrust

B) Takeoff Progress Page

C) Derated Thrust

D) Abort Page

Answer 2

B) Takeoff Progress Page

Question 3

If you are going to use a back course ILS for departure, what course should you set in?

A) Back

B) Alternate

C) Front

D) Emergency

Answer 3

C) Front

Question 4

If V2 is not available for takeoff, the vertical speed mode will engage how long after liftoff?

A) 100 ft.

B) 400 ft.

C) 10 seconds

D) 5 seconds

Answer 4

D) 5 seconds

Question 5

At the acceleration altitude, the Speed Reference System-SRS disengages and the vertical mode automatically switches to either Climb or:

A) Altitude

B) Hold

C) Mach

D) Departure

Answer 5

A) Altitude

Question 6

The navigational mode engages at what altitude?

A) 400 ft.

B) 100 ft.

C) 50 ft.

D) 30 ft.

Answer 6

D) 30 ft.

Question 7

How do you cancel a pre-set heading on the FCU?

A) Pull the Heading knob

B) Push the Heading knob

C) Turn the Heading knob

D) Disconnect the autopilot

Answer 7

B) Push the Heading knob

Question 8

To restore the normal speed target, use what knob on the FCU?

A) Speed

B) Heading

C) Track

D) Vertical Speed

Answer 8

A) Speed

Question 9

The vertical mode window shows Climb as:

A) Takeoff

B) Heading Hold

C) Armed

D) Engaged

Answer 9

C) Armed

Question 10

The FMS automatically switches from preflight phase to takeoff phase when any of the following occur except:

A) Ground speed over 70 knots

B) Thrust levers in the TOGA detent

C) N1 greater than 85%

D) EPR is equal or greater than 1.25

Answer 10

A) Ground speed over 70 knots