Manual of Ops Section III General Standard Operating Guidelines Flashcards
(59 cards)
In reference to pumping standpipes on high rise fires all unnecessary personnel should be kept how far from the apparatus pump discharge outlets and FDC’s
50’
As the pumping engine on a high rise the engineer should only hook to what outlets
Officer side or rear
During a working high rise fire what needs to happen at an additional FDC location
Place 2 engines for additional tandem pumping operation. This secures a separate independent water supply to back-up the initial pump operation and/or supplies additional GPM as needed
During interior standpipe operations the first line should connect to what floor
Floor below the fire
During interior standpipe operations the second line should connect to what floor
Floor above the fire and serve as the back-up line or extraction line
What is the minimum amount of 2 1/2’’ hose that should be brought up to connect to an interior standpipe
150’ (consider 200’)
SHOCKER
Size, Height, Occupancy type, Conditions, Kind of immediate actions taken, Exposure, Resources
The decision to deploy a pre-connected tank line is based on fire assessment by who
1st arriving engine company officer
What are 4 responsibilities of a Company Officer in regards to pre-connected line tactics
-Announce the use of pre-connected lines to responding units
-Secure a water source or request the next in engine to lay a feeder line
-Pass command to next arriving company
-Direct the placement of lines and proper application of water to achieve objectives
When responding to an incident who is responsible for the initial report
1st on scene department member
What are the 3 modes of incident operations
Investigation, Fire Attack, Command
What are the responsibilities of the first in Captain during Investigation mode
Check the area of the structure, talk to a responsible party to determine what prompted the emergency call, and determine what further action is required
What are the responsibilities of the first in Captain during Fire Attack mode
Give the initial report, passing command to the second on-scene engine captain, and enter the fire building to supervise interior operations. “Fire Attack” shouldn’t be used as a radio identifier.
What are the responsibilities of the first in Captain during Command mode
Assign crew to second on scene engine captain and potential development of a complex incident command structure
What are some reasons why a first on scene company would take Command
-Incident requires immediate coordination due to its size, magnitude, and complexity
-An initial offensive attack is inappropriate
What type of staging identifies the position companies should maintain when staged at an incident
Level I Staging
How far should companies stage during Level I staging
1 block in their direction of travel
When companies arrive in staging what should they do
Announce their arrival and state their staged location
What level of staging identifies a central location for resources and automatically requires the implementation of a STAM and staging channel at time of dispatch
Level II
Who should the STAM report to
Incident Commander or Operations Section Chief if it has been established
What are the responsibilities of the company officer when there is a lost or downed firefighter
Activate orange emergency button and voice Emergency Traffic. Provide IC with Who, Where, How Many, Why, What
What does the Evacuation Signal consist of
Repeated short blasts of the air horn for a period no longer than 10 seconds followed by 10 seconds of silence, repeat 3 times
Level I RIC
1 Engine Company
Level II RIC
1 Engine, 1 Truck, & 1 Command Unit