OSHA Flashcards by Deleted Deleted

The Prime Contractor Is Responsible

For Safety - 0.16

How well did you know this?

Not at all

Perfectly

Emergency Actions Plans For Companies With Fewer Than

Ten Persons

Need Not Be In Writing - .35(e)(3)

How well did you know this?

Not at all

Perfectly

Common Drinking Cups Must Not Be Used

Not Be Used - .51(A)(4)

How well did you know this?

Not at all

Perfectly

See Video For List Of Acceptable Types Of Chipping Goggles

102

How well did you know this?

Not at all

Perfectly

Does Employer Provide Protection?

Yes - .102(a)

How well did you know this?

Not at all

Perfectly

Safety belt lanyard shall be ______ Nylon and withstand a Fall of No More Than ____ feet, breaking point ______ Lb.

1/2”, 6, 5400 - .104(d)

How well did you know this?

Not at all

Perfectly

List Class B fire extingusher types -

Foam, Carbon Dioxide, Chemical - .150, TABLE F-1

How well did you know this?

Not at all

Perfectly

A Fire Extinguisher not rated less than______Per _____ Sf of building area.

2A, 3000 - .150(c)

How well did you know this?

Not at all

Perfectly

No more than ______ Gallons Of Flammable Liquids May Be Stored in a room Outside Of
Approved Storage Cabinets

25 - .152 b

How well did you know this?

Not at all

Perfectly

Access Way ______Wide To Within ______ Feet Of Storage Containers

12’, 200, - .152 c (2)

How well did you know this?

Not at all

Perfectly

Every container / vaporizor safety valve shall discharge not less than _____horizontally away from any opening to the building

5 feet - .153(d)(1)

How well did you know this?

Not at all

Perfectly

Distance That Flammable Materials May Be Stored Away

From Liquified Petroleum Gas

0, 10,20,25 - .153(k) TABLE F-3

How well did you know this?

Not at all

Perfectly

Flammable Materials Distance From Heating Device

.154(b)(2) TABLE F-4

How well did you know this?

Not at all

Perfectly

Heating Devices At Least _______Away From Tarpaulins

Ten feet - .154(b)(4)

How well did you know this?

Not at all

Perfectly

Materials stored in a building shall be At Least ______From Exterior Wall

Ten Feet - .250(b)(1)

How well did you know this?

Not at all

Perfectly

Bagged materials shall _______ layers and cross key at least every ____ Bags High

step back, Ten - .250(b)(4)

How well did you know this?

Not at all

Perfectly

Brick Stacks shall not be more than____ high, Loose brick tapered ______for every foot over 4 feet.

7’, 2 inches - .250(b)(6)

How well did you know this?

Not at all

Perfectly

Masonry Block stacked over _____feet shall be taperd ______ per tier.

Six, 1/2 block .250(b)(7)

How well did you know this?

Not at all

Perfectly

Lumber Stack Heights, not to exceed _______, no more than _____ if handled manually

20 feet, 16 feet - .250(b)(8)

How well did you know this?

Not at all

Perfectly

Wire Rope Shall Not Be Used When More Than _____Of The Strands Have Been Damaged Within A Length Of ______.

10% , 8 Diameters - .251(c)(4)(iv)

How well did you know this?

Not at all

Perfectly

Chute Required When Dropping Debris More Than ______Feet.

20 - .252(a)

How well did you know this?

Not at all

Perfectly

When Debris Is Dropped Thru Holes In Floors, A _____ High Barricade _______Outside The Hole Must Be Installed Around The Drop Zone On The Lower Floor.

42”, 6” .252(b)

How well did you know this?

Not at all

Perfectly

Skill Saws Are Required To Have ___________ Guards

“Point Of Operation” - .300(b)(4)

How well did you know this?

Not at all

Perfectly

Compressed Air Used For Cleaning Purposes Shall Not Exceed ?

30 Psi - .302(b)(4)

How well did you know this?

Not at all

Perfectly

Abrasion Wheel safety measures

Sufficient power, Safety guards, spindle end, nut and flange protection - 0.303

Gas Storage Requirements…....Gas Welding and cutting - Know the section

.350(a) & (d)

Welders Working In Confined Spaces…. 3 Requirements

Ventilation, Respirator, Safety line - .353(b)

Scaffolds Must Support At Least ______ The Intended Weight

Four Times - .451(a)(1)

Minimum With Of Scaffold Platforms Is

18" - .451(b)(2)

Maximum Distance From Outrigger Scaffold Platform To | Face Of Building Is

3" - .451 (b)(3)(i)

Maximum Distance From Scaffold To Face Of Building When Applying Stucco Is

18" - .451(b)(3)(ii)

Each End Of A Scaffold Must Extend ____ Past The Scaffold Support

6" - .451(b)(4)

Scaffold Anchor Spacing

20 feet, not more than 30 feet - .451(c)(1)

Scaffolds Erected Under Supervision Of

A Competent Person - .451(f)(7)

Scaffold Handrail Height Between ______ And _______Above Scaffold Platform

36", 45" - .451(g)(4)(ii)

Scaffold Wire Rope Shall Be ______ And Without ________ Between Anchors

Continuous, Splices - .452(r)(4)

Guardrails Are Required When Working More Than ________ High

6' Feet - .501(b)(2)

Guardrails Are Required When Excavation Is Deeper Than _______ Feet

6 - .501(b)(7)

Structurall systems to support _______ Pounds

200 - .502(b)(3)

A Lanyard Should Be Connected At __________ Of The Wearers Back

The Center Point - .502(d)(17)

Covers Must Support _______ The Intended Weight

Twice - .502(i)(2)

Control linse must be located not less than _____feet nor more than _____feet from unprotected edge

6, 25 - .502(G)(1)(i)

Rubber Tired Heavy Equipment Requires Fender if travelling more than_______ MPH

15 - .602(5)

Clearing Equipment Rollover Canopy_____Thick, wire mesh nor than ____ inch

1/8", 1/4" - .604(a)(2)(i)

What is a Kickout?

Anaccidental release or failure of a cross brace - .650(b)

In Excavations More That _____ Deep ladders are located _____ apart.

4 Feet, 50 feet - .651(c)(2)

Air Quality Must Be Tested In Excavations

Prior To Beginning Work - .651 (g)(1)(i)

Minimum Percent Oxygen Is _____, Maximum ______

19.5%, 23.5% - .651(g)(1)(iii)

Materials Stored At Least ______ From The Edge Of An Excavation

2 feet - .651 (j)(2)

Who Inspects Excavations On a Regular Basis?

Competent Person - .651(k)

A Handrail Is Required For Walkways Over Trenches More Than ______ Deep

6 Feet - .651(i)

Employees Must Be Protected From Cave-Ins When Excavation More Than

5' Deep - .652(a)(1)(ii)

Excavations May Be ______ Below Trench Box

Two Feet - .652(g)(2)

Unconfined Compressive Strength, What are two filed tests?

Pocket Petrometer, Thumb Penetration - Appendix A to Subpart P

Maximum Allowable Slopes….. Know this table

Appendix B to Subpart P, TABLE B-1

How shall Formwork be designed?

To withstand verticle or lateral loads - .703(a)

Masonry Wall Over High Shall Be Braced

8 Feet - .706(b)

Persons ____________ Of Loads May Work Under Loads

Responsible For The Hooking - .753(d)(1)(ii)

Structural Steel Assembly Of Multistory Building

Perminant floors installed as structure progresses.754(b)

Solid Floors No More Than ______ Below Steel Erectors

30 feet - .754(b)(3)

When Debris Is Dropped Thru Holes In Floors, A ____High Barricade______Outside The Hole Must Be Installed Around The Drop Zone On The Lower Floor.

42", 6 Feet - 850(h)

A Change In Elevation Of _______Requires A Ladder Or Stairs

19" - .1051A

At Least______Handrail On Enclosed Stairs

One - .1052(c)(1)(i)

When Accessing A Roof With A Ladder, The Ladder Must Extend _____Above The Roof

3 Feet - .1053(b)(1)

Ladders Should Slope So That The Distance From The Base Of The Ladder To The Base Of The Building Is Equal To The Working Length Of The Ladder

1/4 - .1053(b)(5)(i)

The Atmosphere In Confined Spaces Must Be Tested For __________ Prior To Persons Entering.

Oxygen, Flammable Gases, And Toxic Air Contaminants - .1203(e)(2)(iii)

The Distance From A Crane Boom And A Power Line Rated Less Than 50Kv Must Be At Least?

10 Feet - .1408(h) Table A

A Crane Must Be Inspected By ________ Prior To Each Shift

A Competent Person - .1412(d)(1)

Employers must use assigned protection factors listed in table______ that meet or exceed requirements

Table 1 - 1910.134(d)(3)(i)(A)

OSHA Flashcards

(69 cards)